AVTEQ Install Guide

Package Contents

Included with Neat Frame Wall Mount (NEATFRAME-WM):

• A. Wall mount [x1]

  Diagram Description: A line drawing shows the wall mount bracket.

• B. Anchor screw [x3]

  For dry wall

  Diagram Description: A line drawing shows an anchor screw.

• C. #8 1 1/2" wood screw [x3]

  For wood or metal studs

  Diagram Description: A line drawing shows a wood screw.

• D. 1/4-20 3/4" screw [x1]

  Diagram Description: A line drawing shows a screw.

Step 1: Secure Wall Mount to Wall

NOTE: The cutout for the wall needs to be 8.5" wide and 3.8" tall.

NOTE: To secure on dry wall, use the anchor screws (B). To secure on wood or metal studs, use the wood screws (C).

Place the wall mount (A) in the wall. Secure the wall mount using [x3] anchor screws (B) or wood screws (C), depending on the wall material. For a flat installation of the Neat Frame device, insert screws into the bottom three inner holes of the wall mount. For a slight tilt, insert screws into the top three inner holes of the wall mount.

Diagram Description: Screws are shown being inserted into the mount.

Diagram Description: The wall mount is shown attached to a wall with screws placed in the bottom three inner holes for a flat installation.

Diagram Description: The wall mount is shown attached to a wall with screws placed in the top three inner holes for a slight tilt installation.

Step 2: Secure Neat Frame Device to Wall Mount

Secure the Neat Frame device to the base of the wall mount (A) using a [x1] 1/4-20 3/4" screw (D). Screw through the bottom of the wall mount (A).

Diagram Description: The Neat Frame device is shown mounted flat against the wall.

Diagram Description: A screw is shown being inserted through the bottom of the wall mount into the Neat Frame device.

Diagram Description: The Neat Frame device is shown mounted at a slight tilt.

Have a question? Contact AVTEQ at support@avteqinc.com

Visit avteqinc.com for more information.