AVTEQ Install Guide

An illustration depicts the AVTEQ Neat Frame Floor Stand. It is a tall, slender floor-standing mount featuring a stable base and a vertical column, designed to securely hold a display device.

Package Contents

Included with Neat Frame Floor Stand:

• A. Base plate [x1]
• B. Body column [x1]
• C. Rear cover [x1]
• D. Flat 1/4-20 1/2" screw [x1]
• E. Socket M6x1.0 10mm long screw [x2]
• F. Flat 3/8-16 1.25" screw [x3]

Step 1: Secure base to body column

Place the body column (B) on top of the base plate (A). Secure it from the bottom of the base plate using three (x3) flat headed 3/8-16 1.25" screws (F).

Diagram shows the body column being attached to the base plate from underneath.

Step 2: Secure the Neat Frame

Place the Neat Frame on top of the body column (B).

Secure the Neat Frame with one (x1) flat 1/4-20 1/2" screw (D). Screw this from the bottom into the top inner hole of the body column.

Diagram shows the Neat Frame being attached to the top of the body column, with a screw inserted from the bottom.

Step 3: Secure rear cover to the body column

Place the rear cover (C) behind the body column (B).

Secure the rear cover using a wrench and two (x2) socket M6x1.0 10mm screws (E), screwing them into the two top holes of the rear cover.

Diagram shows the rear cover being attached to the body column from behind, with screws inserted into the top holes.