Namron Dimmable LED Driver
Instruction Manual
24V IP66 Dimmable LED Driver
| Input Voltage | 220-240V~ 50/60Hz |
| Output Voltage | 24V 8.34A |
| Total Power | 200W |
| Dimmable | Yes |
| Ambient/Case Temperature (Ta/Tc) | 40°C/80°C |
| Isolation Class | I |
| Ingress Protection (IP) | IP66 |
| Protections | Overload protection, Over-temperature protection, Short-circuit protection |
Certifications: SELV, CE
Dimensions and Measurements
The LED driver is a rectangular aluminum extrusion designed for efficient heat dissipation. The overall dimensions are:
- Total Length: 232.4 mm
- Width: 62 mm
- Height: 45.4 mm
- Main body length (finned section): 200 mm
- End cap width: 77.4 mm
Input AC wiring typically uses Brown for Line (L) and Blue for Neutral (N). Output DC wiring uses Red for positive (+) and Black for negative (-).
Wiring Instructions
Ensure the power is turned off before installation.
1-Pole Wiring
For single-pole dimming control:
- Connect the AC input (Line 'L' and Neutral 'N') to the driver's input terminals.
- Connect the dimmer control signal to the driver's input terminals (typically terminals 1 and 2 for phase-cut dimming).
- Connect the DC output (Red for positive '+', Black for negative '-') to the LED strip.
Safety Warning: Turn off power before installing.
2-Pole Wiring
For two-pole dimming control:
- Connect the AC input (Line 'L' and Neutral 'N') to the driver's input terminals.
- Connect the dimmer control signal to the driver's input terminals (typically terminals 1 and 3 for phase-cut dimming).
- Connect the DC output (Red for positive '+', Black for negative '-') to the LED strip.
Safety Warning: Turn off power before installing.
Manufacturer: Namron AS, Nedre Kalbakkvei 88, N-1081 Oslo, NORWAY.
