Back wall for C404013
Back wall closed
(suitable for 40GP and 40HQ containers)
Diagram of Back Wall Dimensions
A representation of the back wall's dimensions, showing a semicircular top structure supported by a rectangular base. Key dimensions indicated are 2930mm segments along the base, totaling 11850mm, with an overall width of 12000mm. The height is indicated as 4000mm. A component labeled '13' is shown at the apex of the semicircular structure.
Parts List
| Qty | Description | Qty |
|---|---|---|
| 1 | Base plate at middle of back wall | 3 |
| 2 | Base plate at side of back wall | 2 |
| 3 | Side Below standing leg next to the container | 2 |
| 3A | Side upper standing leg next to the container | 2 |
| 4 | Added standing legs to suit HQ container | 5 |
| 5 | Below standing leg | 3 |
| 5A | Middle standing leg | 3 |
| 5B | Middle upper standing leg | 1 |
| 6L | Side upper standing leg at left | 1 |
| 6R | Side upper standing leg at right | 1 |
| 7 | clip | 7 |
| 7A | bolt for clip | 14 |
| 8 | Welded iron for frame | 5 |
| 9 | 2 holes angle iron | 1 |
| 10 | Middle Horizontal tubes | 6Group |
| 10A | Side Horizontal tubes | 2 |
| 11 | Bottom tensioning tubes for back wall | 4Group |
| 11A | Protection parts | 4 |
| 11B | End cap | 8 |
| 11C | Expansion screw M12*100 | 10 |
| 12 | Expansion screw M16*150 | 12 |
| 13 | Back endwall cover | 1 |
| 14 | Rope | 160m |
| 15 | Carriage bolts M10*90 | 46 |
| 16 | Carriage bolts M12*110 | 16 |
| 17 | Bolts M10*30 | 10 |
| 18 | Carriage bolts M8*80 | 20 |
| 19 | Carriage bolts M8*60 | 16 |
Back Wall Assembly
The assembly process involves connecting various parts using screws and bolts. The diagrams illustrate the placement of components such as base plates (1, 2), standing legs (3, 3A, 5, 5A, 5B, 6L, 6R), horizontal tubes (10, 10A), and tensioning tubes (11). Specific fasteners like clips (7) with bolts (7A), angle iron (9), and expansion screws (11C, 12) are used. Detailed views show how parts like protection parts (11A), end caps (11B), and bolts (15, 16, 17, 18, 19) are integrated into the frame structure.
The assembly requires careful attention to spacing and the correct use of expansion screws for base plates. The diagrams provide a visual guide to the correct positioning and connection of each component to form the back wall structure.
Attaching the Back Cover
The back endwall cover (13) is to be attached to the assembled back wall structure using ropes (14). The ropes are used to tie the cover securely to the back wall.
Maintenance: After assembly, it is recommended to adjust and tighten the ropes once per month to ensure the structure remains secure and functions correctly.
