OttLite Rechargeable LED Travel Light

Introduction

CONGRATULATIONS! You've purchased the finest in natural lighting technology with your new OttLite® product.

Product Registration

Please complete the enclosed Product Registration Form and return it today by mail, or register online by going to: OttLite.com/warranty.

Product Operation

NOTE: THIS UNIT IS FULLY ASSEMBLED

1. Remove lamp from packing, placing lamp body base [A] flat on a steady surface.
2. To open lamp, hold lamp body base [A] firmly and lift middle body section [B] upward to a triangle shape manner as pictured (or horizontal, if desired), then place LED Light Source [C] as needed.
3. Turn the lamp ON & OFF by using power switch [D] located in the front-upper side of LED Light Source [C].
4. Switch [D] also controls the lamp's light dimming function. Slightly touch switch [D] to engage dimming function from "high" to "low".
5. Charge product using included USB cable or AC adapter.
6. To set calendar and alarm see "Setting Calendar and Alarm" section.
7. To install or remove button cell battery see "Battery Install" section.
8. To set temperature transfer see "Temperature Transfer" section.

Setting Calendar and Alarm

Setting Date and Time:

1. Under normal mode, press SET key and enter date and time setting mode, press SET again to enter the next setting. The sequence of setting is: HOUR-MINUTE-YEAR-MONTH-DAY-BACK.
2. Press UP [arrow-up] and DOWN [arrow-down] to adjust settings; the day of the week will vary accordingly.
3. Under setting mode, press MODE key or no operation in 60 seconds will exit set mode, and display the time.
4. Under normal mode, press UP [arrow-up] to transfer between 12 and 24 hours format.
5. A CR2025, 3V Lithium battery is needed to power the calendar.

Snooze Alarm Function:

1. Under normal mode, press MODE key to enter alarm mode.
2. Under alarm mode, press "SET" key to enter alarm setting, press "SET" again to enter the next setting. The sequence of setting is: HOUR-MINUTE-SNOOZE-MUSIC-BACK.
3. Press UP [arrow-up] and DOWN [arrow-down] keys to set.
4. Under alarm mode, press UP [arrow-up] and DOWN [arrow-down] keys to open and close the alarm and snooze functions. Press them again to cycle through functions: OPEN alarm, OPEN snooze, CLOSE alarm and snooze.
5. When "alarm time" is reached, the alarm will last 1 minute. If snooze time is reached, the alarm will ring again. Press "SET" key or any button to stop the alarm.

Temperature Transfer and Battery Installation

1. Under normal mode, press DOWN [arrow-down] key to transfer between Celsius (°C) and Fahrenheit (°F).
2. To remove/install button cell battery: remove battery compartment door located in the lower half of middle body section [B] back-side of lamp. Turn door clockwise to remove and counter-clockwise to install. Button cell battery is to be installed with the "+" or flat side facing upward.

Important Safety Information

NOTE: The important safety instructions appearing in this instruction sheet are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and care must be used with any electrical product.

Caution!

Any change or modification to product not expressly recognized by OttLite Technologies voids OttLite's responsibility for proper function of product.

FCC Part 15 Compliance

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that of the receiver.
• Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3 (B)

Battery Information

CAUTION:

This Product contains a built-in Lithium-ion (Li-ion) battery. This is a non-replaceable battery. In the event of faulty battery, entire product shall be properly disposed.

Li-ion Battery

• Model: TY-523450A
• Capacity: 1000mAh (3.7Wh)
• Output Voltage: 3.7V

NOTICE:

• Never disassemble by yourself.
• Use the authorized charger only.
• Exposure of battery to open flames could cause explosion.
• Do not expose the battery pack out of the temperature range 32°F to 113°F (0°C~45°C).

MADE IN CHINA

Specifications

• USB: 5V, 500mA / Input power: 5V/500mA
• Battery: Lithium, 3.7V / 1000mAh (power for LED Lights)
• AC Adapter: Input: 100-240V, 50/60 Hz, 0.3A / Output: 5.0V DC, 500mA

Accessories

• USB cord
• AC Adaptor
• Wall mount with adhesive