VEVOR Drywall Stilts User Manual

Contact Us

For product questions or technical support, please contact VEVOR customer service at CustomerService@vevor.com.

This is the original instruction manual. Please read all instructions carefully before operating the product. VEVOR reserves the right to interpret this user manual. The appearance of the product is subject to the actual item received. VEVOR may update technology or software without prior notice.

Safety Instructions

1. Inspect the stilts thoroughly before use. Ensure all parts are free of damage and all bolts and screws are fully tightened.
2. Use this product only on level and flat ground surfaces, ensuring no low-profile furniture or other obstructions are present.
3. When adjusting the height, remove the stilts from your legs first for safety.
4. Ensure all straps are fastened and secured before walking on the stilts.
5. When walking, take small steps. Ensure the stilts are raised well above the ground with each step.
6. Never use the stilts on slippery ground.
7. Do not overload the stilts.
8. Walk slowly. Do not run or walk fast on the stilts.
9. Do not modify the stilts arbitrarily.
10. Do not use the stilts if influenced by alcohol or drugs.
11. Children are not allowed to use this product. Minors and seniors are not recommended users.
12. Ensure the surrounding area is clean when using the product. Always wear protective gear (especially knee and elbow pads) and a helmet. Beginners are recommended to use two supporting sticks for balance.
13. Using this product on public roads or streets is forbidden.
14. When using the product, it is recommended to wear anti-slip shoes.
15. The intended purpose of this product is for architectural decoration or ceiling repair, not for entertainment or dancing.
16. It is recommended to have two other people assist the user in standing on the stilts.

Package Content

• Skid-proof Rubber Sole x 2
• Metal Buckle x 2
• Supporting Stick x 2
• Bolt x 4
• Nut x 4
• 3-Position Heel Bracket x 2

Specifications

Assembly Instructions

The assembly procedures for both stilts are identical. The following steps demonstrate the assembly using one stilt as an example.

Step 1

Insert the supporting stick through the side hole on the left stilt. Secure the end of the supporting stick to the side bracket of the left stilt using the pre-installed bolt and nut.

Step 2

Install the 3-position heel bracket on the top of the stilt using two bolts and two nuts.

Step 3

Thread the ends of the strap through the skid-proof rubber sole. Then, thread the end of the strap through its buckles. Fasten the strap securely. Ensure the strap is tightly fastened; preparation is complete.

Using the Stilts

Use the straps on the stilt to secure your feet. Ensure the straps are fastened tightly.

Adjust the Stilt Height

NOTE: Before adjusting the height, remove your feet from the stilts.

Step 1

Loosen and separate the 4 bolts on the stilts.

Step 2

Adjust the height of the stilts. Ensure that the heights of both stilts are the same. After adjustment, fasten the bolts securely.

Importer and Manufacturer Information

Importer: WAITCHX
Address: 250 bis boulevard Saint-Germain 75007 Paris

Importer: FREE MOOD LTD
Address: 2 Holywell Lane, London, England, EC2A 3ET

Manufacturer: Suzhou Hongcai Exhibition Equipment Co.,Ltd.
Address: No.429, Caifu Road, Cailian, Linhu Town, Wuzhong District, Suzhou, China

Made in China