Sealey Superline Pro ® 6 Drawer Tool Cabinet with Ball Bearing Slides

1. SAFETY

WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this Topchest & Rollcab combination.

• Locate the tool cabinet in a suitable working area.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Keep the tool cabinet clean and tidy in accordance with good workshop practice.
• Keep children and unauthorised persons away from the working area.
• DO NOT use the tool cabinet for any purpose other than that for which it is designed.
• DO NOT open more than one drawer at the same time.
• DO NOT step on the drawers.
• DO NOT use in damp work areas.

WARNING! The warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the operator.

2. INTRODUCTION

Manufactured from double skin side walls. Full length locking bars secure all drawers when the lid is closed which can then be locked by the barrel lock supplied with two keys. Coated in high-gloss triple baked enamel for protection against oil, dirt and mild solvents. Full length TPR anti-shock protective bumpers on all corners prevent damage when moving around the workshop. Fitted with four stylish Ø5" x 2" castors, two fixed and two swivel with brakes and a durable shatter proof plastic side handle. Supplied with a can storage tray, waste bin and paper roll holder. Six drawers each supplied with a cut-to-size non slip liner. Deep storage compartment inside of the gas strut lid supplied with non slip liner.

3. CONTENTS

Parts contents are listed as in fig. 1

fig.1

4. ASSEMBLY

Diagrams illustrating assembly steps are provided. These show the placement and connection of various parts labeled [01] through [19] to construct the tool cabinet. Key steps involve attaching side panels, drawer slides, castors, handles, and locking mechanisms as depicted in figures 2 through 5.

fig.2

fig.3

fig.4

fig.5

fig.6

5. OPERATION

5.1. To lock the top chest, close all drawers, then insert one lock bar into the back slot inside the top compartment. Close the lid and lock with the key.

6. MAINTENANCE

• 6.1. Periodically lubricate the drawer slides.
• 6.2. Clean the surfaces with a soft cloth and a mild water/detergent solution.
• 6.3. Check all fixings and tighten if required.