Instruction Manual for ISC models including: TC100, NESSIE, TC100 Nessie Lanyard Management Clip, TC100, Nessie Lanyard Management Clip, Lanyard Management Clip, Management Clip
ISC Nessie Lanyard Manager
ISC Nessie Lanyard Management Clip | Next Day Delivery
TC100 NESSIE Lanyard Management Clip NESSIE International Safety Components Ltd. Unit 1, Plot 2 Llandygai Industrial Estate Bangor Gwynedd LL57 4YH United Kingdom TC100 NESSIE September 2024 Fitting the NESSIE to a Harness 1. Unscrew and remove the barrel nut and screw from the body of the NESSIE, using two flathead screwdrivers. 2. Select a location on the waistband webbing of the harness 3. Slide the attachment arm of the NESSIE in between the waistband webbing and the back pad of the harness. 4. Align the fixture arm hole with the corresponding hole in the body of the NESSIE. 5. Insert the barrel nut into the aligned holes and then insert the screw into the barrel nut. Tighten the nut and screw together, using two flathead screwdrivers Slotted screwhead NOTE in the absence of two flathead screwdrivers, other flat implements can be used to operate the screws. WARNING: Do NOT use sharp implements for this purpose. Over time, burrs may occur on the head of the screw. These should be removed using a fine grade abrasive paper/file. Stowing the Lanyard: 1. Start by pushing the trailing end of the lanyard rope, into the bottom slot of the NESSIE. 2. Create a loop in the rope and insert another section of rope into the second slot. Continue to loop and insert rope, until all slots are filled. 3. The Snaphook/connector can be hooked over the head of the NESSIE 4. If using a connector on the trailing end of the lanyard and/or on an adjustor (ropegrab, etc.), these connectors can be clipped into the aperture. The aperture can accommodate multiple connectors, simultaneously. Part Code TC100A1 Lime Green, TC100B1 Green, TC100C1 Blue, TC100D1 Orange Max. Harness Webbing Width 50mm (2") Harness Attachment Fixture Maximum Rope Diameter Multi-use (and replaceable) Nyloc Screw 13mm (1/2") Maximum Lanyard Weight 10kg (22lbs) Weight (without lanyard/connectors) 52g (1.8oz) Material Durable, flexible Polymer Recommended Temperature Range 0°C to 45°C (32°F to 113°F) (Functional in termperatures as low as to 20°C (-4°F) Standards NOT for PPEMicrosoft Publisher 2019