DC Power Ceiling Fan Remote Control Manual

Learning Process

NOTE: This unit is to be used for the control of DC power ceiling fans and operates on an AC110/120V 60Hz power supply only.

1. Open the remote battery cover and install CR2032*2pcs Lithium batteries.
2. Within 30 seconds of turning the Receiver's AC power ON, use a ball pen to press and hold the Set key for about 5 seconds. Once the receiver has detected the frequency, it will make a "Bi Bi" sound twice. This indicates the receiver has learned the frequency previously selected on the transmitter.

Note: After the AC power is on, do not press any other button on the transmitter before setting the learning process. Doing so will cause the procedure to fail.

After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmitter, turn the power off to the receiver and repeat step 2.

Light Function Select Switch

If an energy-saving light is installed onto the ceiling fan, slide the dip switch (light function select switch) to the "O" position. If a tungsten light is installed onto the ceiling fan, slide the "light function select switch" to the "D" position.

Functions of Wall Remote Control

• LED: Indicates fan or light function setting.
• FAN key: Press to turn the fan on or off.
• Fan Speed Control Key: Press the ▲ or ▼ key each time to change fan speed.
• Light Control Key:
• ON/OFF: Press and release immediately to turn the light on or off.
• DIMMER: Press and hold the ▲ or ▼ key to dim or brighten the light to the desired level and release. (Tungsten only and light function select switch on dimmer position.)

Timers

• 1hr: Setting up that the ceiling fan will turn off after 1 hour automatically.
• 3hr: Setting up that the ceiling fan will turn off after 3 hours automatically.
• 6hr: Setting up that the ceiling fan will turn off after 6 hours automatically.

Home Shield

Press and hold the buttons for 3 seconds. The fan will be off and the light will randomly turn on and off while you are away from home.

Additional Features

• Walk Away Light Delay: Tap once; the light and fan turn off after 1 minute automatically.
• Natural Wind: Press the key for set fan speed for making natural wind.
• Forward Airflow: Press the key for forward airflow of ceiling fan.
• Reverse Airflow: Touch icon for reverse airflow of ceiling fan.

Federal Communications Commission (FCC) Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.

FCC ID: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.