TV mount, Monitor mount, Desk mount, TV Stand, Speaker mount,
Instruction Manual for WALI models including: SWM202 Speaker Wall Mounts, SWM202, Speaker Wall Mounts, Wall Mounts
SWM202-W User Manual (PDF) WALI WALI WALI,Speaker,Wall,Mounts,,Bookshelf,Speaker,Wall,Mount,Brackets,,Surround,Sound,Speaker,Mounts,,Hold,up,to,7.7,lbs,,(SWM202-W),,2,Pack,,White,B0BLJH14T3,B09M3SVZB8,B0784876S1,B09M3S4BKP,B077P8YX6S
WALI Speaker Wall Mounts, Bookshelf Speaker Wall Mount Brackets, Surround Sound Speaker Mounts, Hold up to 7.7 lbs, (SWM202-W), 2 Pack, White : Electronics
File Info : application/pdf, 4 Pages, 2.24MB
DocumentDocument,167$//$7,210$18$/ Speaker Wall Mount SWM202 / SWM402 / SWM602 SWM202-W / SWM402-W/ SWM602-W RATED ¶E www.walielectric.com support@walielectric.com 1-844-SATTLER (18447288537) 2 Supplied Parts List SWM202 A (x2) M5x12 Bolt B (x4) M6x12 Bolt C (x2) 1/4" -20x1/2" Bolt ST4.2X25 Screw ¶6X25 Anchor D (x2) E (x4) F (x4) Step 1 Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. Tighten wood screws firmly but do not overtighten. Over tightening can damage the screws, greatly reducing their holding power. Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended. Step 2 Option A : Wood Stud Mounting Use a stud finder to locate the edges of the studs. Using an edge-to-edge stud finder is highly recommended based on their edges and drew a vertical line down each stud's center. E Place metal wall plate on the wall as a template. And mark the center of the two mounting holes. Make sure that the mounting holes are on the stud centerline. Drill two 1/8" (3mm) dia. Holes 1" (25mm) deep. Secure it using two screws (part - E ). Make sure that the wall plate is level as shown in the figure. 3 Option B : Sold Brick and Concrete Wall Mounting Use the metal wall plate as a template to mark two holes on the wall as shown in the figure. Drill two 7/32" (5.5mm) dia. Holes 1.2" (30mm) deep. Insert a Concrete Anchor (Part- F ) into each of these holes. Attach the wall plate to the wall using two screws (Part- E), make sure that the wall plate is level as shown in the figure. F E Step 3 BCD Hand thread bolts into the threaded inserts on the back of your Speaker to determine which bolt to use. Attach Speaker to top bracket using Bolts B C D . Step 4 Lastly, assemble the Speaker with the top bracket onto the bracket set and wall plate securely. Step 4 Angle adjustments. 4