MAULcaligo 940 80 Coat Stand

Product Overview

The MAULcaligo 940 80 is a functional and stylish coat stand designed for everyday use. This document provides a comprehensive guide to its assembly and identification of its components.

Parts List

The following components are included in the package:

• Base Plate: 1x (Part 1)
• Screw M8 x 45: 1x (Part 2)
• Screw M8 x Ø25: 1x (Part 3)
• Base Disc: 1x (Part 4)
• Base Ring: 1x (Part 5)
• Lower Pole Section: 1x (Part 6)
• Middle Pole Section: 1x (Part 7)
• Upper Pole Section: 1x (Part 8)
• Hook Assembly Base: 1x (Part 9)
• Hook: 1x (Part 10 - Representative, multiple hooks are attached in final assembly)
• Pole Connector/Cap: 1x (Part 11)
• Ring/Collar: 2x (Parts 12 & 14)
• Tool/Wrench: 1x (Part 13)
• Small Parts: 3x (Part 15)
• Screws (M4 x 10): 8x (Part 16)

Note: The diagrams on page 2 suggest that the coat stand is equipped with 3 hooks, assembled from components labeled 12, 14, and 15, and attached using brackets (labeled 13 in a different context) and screws (labeled 16 in a different context). The primary exploded view on page 1 shows a single hook (10) for illustrative purposes.

Assembly Instructions

Follow these steps to assemble your MAULcaligo 940 80 coat stand:

1. Assemble the Base:

   Place the base disc (4) and base ring (5) onto the base plate (1). Secure these components using the M8 x 45 screw (2) and the M8 x Ø25 screw (3).

2. Assemble the Pole:

   Connect the lower pole section (6), middle pole section (7), and upper pole section (8) together. These sections are designed to screw into each other or connect via an internal fitting.

3. Attach Hook Assembly Base:

   Secure the hook assembly base (9) to the top of the assembled pole sections.

4. Attach Hooks:

   Attach the hooks to the hook assembly base. The diagrams indicate that 3 hooks are typically fitted. Ensure hooks are attached securely, following the correct method shown in the illustrations (refer to page 2 of the original document for visual guidance on correct hook attachment).

5. Final Touches:

   Place the pole connector/cap (11) on the top of the pole if applicable. The rings/collars (12, 14) and small parts (15) may be decorative elements or additional fittings.

Important Notes

Correct Hook Attachment: Ensure hooks are attached firmly to prevent them from falling off. Refer to the provided diagrams for the correct method of attaching the hooks to the upper pole.

Packaging and Disposal: Information regarding packaging and disposal is available in multiple languages (French, Italian, Bulgarian) in the original document.