Waterpik Sonic Fusion SF-01 / SF-02

Important Safeguards

DANGER: To reduce the risk of electrocution:

• Do not handle plug with wet hands.
• Do not place in or drop into water or other liquid.
• Do not use while bathing.
• Do not place or store product where it can fall or be pulled into a tub or sink.
• Do not reach for a product that has fallen into water. Unplug immediately.
• Check the power supply cord for damage before the first use and during the life of the product.
• The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped.

WARNING: To reduce the risk of burns, electrocution, fire, or injury to persons:

• If product is opened/disassembled for ANY reason, warranty is VOID.
• Do not use this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into any liquid. Contact Water Pik, Inc. or your local distributor which can be found at www.Waterpik.com.
• Do not direct water under the tongue, into the ear, nose or other delicate areas. This product is capable of producing pressures that may cause serious damage in these areas.
• Do not direct water into the nose or ear. The potentially deadly amoeba, Naegleria fowleri, may be present in some tap water or unchlorinated well water and may be fatal if directed into these areas.
• Use this product only as indicated in these instructions or as recommended by your dental professional.
• Only use flossing brush heads and accessories recommended by Water Pik, Inc.
• Do not drop or insert any foreign object into any opening or hose.
• Keep electrical cord away from heated surfaces.
• Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
• Fill reservoir with water or other dental professional recommended solutions only.
• Remove any oral jewelry prior to use.
• Do not use if you have an open wound on your tongue or in your mouth.
• If your physician or cardiologist has advised you to receive antibiotic premedication before dental procedures, you should consult your dentist and/or medical professional before using this product or any other oral hygiene aid.
• Do not use iodine or water insoluble concentrated essential oils in this product. Use of these can reduce product performance and will shorten the life of the product. Use of these products may void warranty.
• Close supervision is necessary when this product is used by, on or near children or invalids.
• Magnetic field: Pacemakers and similar implanted medical devices may be affected by magnet.
• Do not use the toothbrush motor for more than 5 minutes in each 10 minute period.
• Children should be supervised to ensure that they do not play with the appliance.
• This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
• This product does not contain any user serviceable parts. Do not attempt to open except for battery disposal. See "Battery Removal" section.
• Using toothpastes containing peroxide may damage the plastic housing of this product.
• Using abrasive or chemical cleaners may damage the plastic housing of this product.
• IMPORTANT This device uses wireless communication to control the on/off function of the water flosser pump motor from the toothbrush power handle. This device was designed for Home or Office use. To avoid electromagnetic interference, do not operate this device in restricted locations such as aircraft or specially marked areas in hospitals.

SAVE THESE INSTRUCTIONS

Product Description

The Waterpik Sonic Fusion combines sonic brushing with water flossing technology. Key components include:

• 1. Brush head
• 2. Water flosser nozzle
• 3. Hinged Lid
• 4. Reservoir
• 5. Water hose
• 6. Water flosser pressure control dial (numbered 2 to 8)
• 7. Water hose release button (round button on the back of the power handle)
• 8. Toothbrush ON/OFF button
• 9. Motion activated ring lights* (on select models)
• 10. Water flosser ON/OFF button
• 11. Power handle
• 12. Toothbrush charge indicator lights
• 13. Power cord
• 14. Charging base
• 15. Indicator Light (blue)

Recommendation: Replace brush head every 3 months.

Diagram Description: A visual representation shows the main unit with the reservoir, hose, and power handle. The power handle is shown with the brush head attached. The pressure dial is visible on the base unit. Indicator lights are shown on the handle and base.

Preparing the Unit

Powering the Unit: Plug the cord into an electrical outlet. Ensure the wall switch controlling the outlet is turned on.

Attaching the Brush Head: Position the brush head on the power handle and press firmly until it clicks. To remove, pull firmly.

Attaching the Power Handle to the Hose: Place the power handle onto the hose in the base and press firmly until it clicks. To remove, press the round button on the back of the power handle.

Charging the Sonic Fusion: Charge for at least 20 minutes before first use. For a full charge, leave on the charging base for at least 4 hours. A full charge lasts approximately 14 uses (2 minutes each). For long-term storage (6+ months), fully charge before storing.

Charge Lights: Indicator lights show battery level for about 10 seconds after removal from the charger and after use, then turn off. A low charge (bottom light lit) indicates recharging is recommended.

Indicator Light (Blue): Blinks when the unit is first plugged in, when the handle is placed on or removed from the charger, or when a wireless command is received.

Preparing the Reservoir: Remove the reservoir, fill with warm water, close the lid, and replace it firmly on the base.

Prime Unit (First Time Use Only): Point the brush head into a sink. Press the 'Floss' button and rotate the pressure control dial between low and high until water flows. Press 'Floss' again to stop water flow.

Brushing and Flossing

Brushing:

• Place the brush head in your mouth before pressing the BRUSH button.
• Technique: Position the brush along the gumline at a 45-degree angle. Use light pressure and move the toothbrush slowly, allowing the sonic action to clean each tooth. The brush can be disconnected from the hose for easier maneuverability.
• Quad Timer: The unit pauses every 30 seconds to indicate when to move to the next section of your mouth (30 seconds for outer surfaces, 30 seconds for inner surfaces, repeated for upper and lower arches, totaling 2 minutes).
• 2 Minute Timer: The brush automatically shuts off after 2 minutes.

Flossing:

• Always place the brush head in your mouth before pressing the FLOSS button. Lean over the sink and slightly close lips to prevent splashing while allowing water to flow into the sink.
• Adjusting Pressure: Start with the lowest setting (No. 1) and gradually increase to your preferred level or as recommended by your dental professional.
• Technique: Start with back teeth and move towards the front. Angle the nozzle slightly toward the gumline. Move along the gumline, pausing briefly between teeth to clean between them. Clean both inside and outside surfaces of upper and lower teeth. Empty any remaining liquid from the reservoir when finished.

Brush + Floss: Place the brush head in your mouth. Press the BRUSH button, then press the FLOSS button to use both functions simultaneously.

Care and Maintenance

Before cleaning, unplug the unit.

After Each Use:

• Remove the brush head from the handle and rinse both under running water.
• Wipe the handle dry.
• Store the handle on the charger and keep the unit plugged in. The unit will not overcharge.

General Cleaning / Removing Hard Water Deposits:

• Clean with a soft cloth and mild, non-abrasive cleanser.
• To remove hard water deposits: Add 2 tablespoons of white vinegar to a full reservoir of warm water. Point the handle and brush head into a sink. Turn the Water Flosser ON and run until the reservoir is empty. Rinse by repeating with a full reservoir of clean warm water. Perform this process every 1 to 3 months for optimal performance.

Toothbrush Low Charge Lock Out: If the battery charge is too low, the indicator lights will flash, potentially causing a lock-out mode. To clear, place the power handle on the charging base.

Leakage: If leaking due to a damaged hose, replacement hoses can be purchased at www.waterpik.com or by contacting Water Pik Inc. customer service.

Travel and Hose-Free Brushing

The toothbrush can be disconnected from the Sonic Fusion unit for travel or hose-free brushing. Store the handle and brush head(s) in the provided case.

Note: To disconnect the toothbrush from the water hose, press the round button on the back of the power handle.

Using Mouthwash and Other Solutions

The Sonic Fusion can be used with mouthwash and antibacterial solutions. After using any special solution, rinse the unit by partially filling the reservoir with warm water and running the unit with the brush head pointed into the sink to prevent clogging.

Battery Removal

This product contains non-replaceable rechargeable Nickel Metal Hydride batteries. For recycling at the end of the product's life:

1. Deplete the battery charge until the brush no longer operates.
2. Gather a towel/cloth, hammer, flat-head screwdriver, and wire cutters.
3. Remove and discard the brush head.
4. Cover the handle entirely with the towel/cloth.
5. Secure the top of the handle against a work surface with one hand. Strike the handle housing around the bottom perimeter on all sides to release the end cap latch. Continue striking and rotating until the end cap releases.
6. Turn the handle upside down. While holding the housing, press the shaft firmly on a hard surface to slide out the internal components. Repeat steps 5-6 if necessary.
7. Remove the end cap from the internal assembly.
8. Slide the battery out of the internal assembly.
9. Cut the battery wires one at a time with wire cutters.
10. Recycle and dispose of the battery and product components according to local regulations.

Note: This process is not reversible and will destroy the product.

Limited Three-Year Warranty

Water Pik, Inc. warrants this product to be free from defects in materials and workmanship for 3 years from the date of purchase. Proof of purchase (receipt) is required for warranty claims. Water Pik, Inc. will replace defective products, provided they have not been abused, misused, altered, or damaged, and were used according to instructions and with approved accessories. This warranty excludes accessories like tips and brush heads. It grants specific legal rights which may vary by location.

Arbitration: By purchasing or using this product, you agree to binding arbitration for any disputes, waiving the right to a jury trial or class action participation. Arbitration will be administered by the American Arbitration Association in Colorado.

Limitation of Liability: Water Pik's liability is limited to the warranty replacement of the product and does not extend to indirect, incidental, or consequential damages.

Compliance Information

For USA Only: This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: no harmful interference, and acceptance of received interference. Modifications not expressly approved by the responsible party may void the user's authority to operate the equipment. This equipment complies with Class B digital device limits.

For Canada Only: This device complies with Industry Canada's license-exempt RSS standards. Operation is subject to two conditions: no interference, and acceptance of any interference.