BUILT BRIGHT

WARNING - BEFORE INSTALLING THIS PRODUCT

⚠️ Verify all parts listed are in the box. If any parts are missing, please contact your authorized dealer for assistance.

Read and understand all warnings and safety guidelines.

Inspect product for damage. If damage is found DO NOT INSTALL. Please see your authorized dealer for warranty support.

Verify that electrical system can support the specified voltage limits for this product.

If you are not qualified to work on vehicular wiring systems, please seek professional advice and/or installation.

SPECIFICATIONS:

Diagram shows the light bar dimensions: 15 inches (381mm) length, 8.7 inches (220mm) width, and 1.8 inches (45mm) height. A smaller diagram shows a 1.5 inch (37mm) depth.

• Dimension: 15" L x 8.7" W x 1.8" H
• LED Count: 112
• LED Color: Amber and White
• Patterns: 44
• Voltage: 12~24V DC
• Maximum Current: 6A @12V DC
• Maximum Power: 72W
• Operating Temperature: -40°F to +149°F
• Recommended Fuse: 8A
• IP Rating: IP69K

INCLUDED

• 1x LED Light Bar
• 1x Cigarette Plug Switch
• 2x U Mount Bracket and Mounting Hardware
• 4x Magnet Mount and Mounting Hardware
• 4x Stud Mount Insulation and Mounting Hardware

INSTALLATION

Four magnet pads are mounted by default on the light bar. To switch to the bolt mount or U mount:

1. Remove the magnet pads.
2. Use the M6 threaded stud and non-slip nuts to mount on any surface or mounting bracket.
3. Place the mounting gasket between the bottom of the light bar and the mounting surface to absorb vibration.

Diagrams illustrate mounting options and hardware:

• Magnet Mount: Diagram shows the light bar with magnet pads attached. Label A: Magnet Pads.
• U Mount Hardware: G: M6 Bolt, H: Mounting Gasket, I: M6 Flat Washer, J: M6 Lock Washer, K: M6 Nuts. Also shown: L: Mounting Gasket, M: U Mount Bracket, N: M6 Flat Washer, O: M6 Lock Washer, P: M6 Bolt.
• Bolt Mount Hardware: B: Mounting Gasket, C: M6/25mm Threaded Stud, D: M6 Flat Washer, E: M6 Lock Washer, F: M6 Nut.

WARNING!

For safe operation of the Vacuum Magnet Mount, do not exceed 45 mph (72 km/h) on a steel roof. Exceeding this speed may cause the mount to fail, resulting in the mini bar detaching which poses a risk of damage and injury. This mount is not for permanent use and must be installed on magnetic surfaces (not fiberglass or aluminium). Keep the magnet clean for optimal performance. Prolonged exposure to moisture can cause rust.

MODE OPERATION

Flash Pattern Selection:

• 1. Press the Pattern Selection button for less than 1 second to switch to the next pattern.
• 2. Press and hold the Pattern Selection button for 1-3 seconds to switch to the previous pattern.
• 3. Press and hold the Pattern Selection button for more than 10 seconds to switch to the default pattern.

Color Selection:

• 1. Press and hold the Pattern Selection button for 3-5 seconds to cycle through amber, white, and amber/white color modes.
• 2. Press and hold the Pattern Selection button for more than 5 seconds to switch to low power mode.
• Press and hold for another 5 seconds to switch back to high power mode.

Diagram of the Cigarette Plug Switch shows three states: Power on (Mode 1), Power off, and Power on (Mode 2).

FLASH PATTERNS