Boult Audio XPods User Manual

Product Picture

1. Smart finger touch: [touch control]

2. Earbuds sounds hole: [sound outlet]

3. Pods Charging point: [earbud charging contacts]

4. Case Charging point for Pods: [charging contacts]

5. Type-C charging port: [USB-C port]

6. Charging LED Indicator: [LED indicator]

Power On

Automatic Power On

1. Take the earbuds out of the case. They will automatically turn on and pair with each other.

Manual Power On

2. Long press for 2 seconds to power on, if the case is not at hand.

Power Off

Automatic Power Off

1. Earbuds will automatically turn off and enter charging mode when they are placed in the case.

Manual Power Off

2. Disconnecting the Bluetooth from the device and laying the earbuds down for 3 minutes will turn them off.

Pairing

For the first-time pairing, take the earbuds out of the case and search for "Boult Audio XPods" on your cell phone, then tap to connect.

Regular use: Once next use, the earbuds will automatically connect with a pre-connected device.

Clear Pairing Record

To clear the pairing record of earbuds and mobile phones: Take out the earbuds from the charging case, and touch the left and right earbud 5 times. This will clear the record of the Bluetooth device. Then search for the Bluetooth name "Boult Audio XPods" to pair.

Resume Pairing of Left and Right Earbuds

Put earbuds in the charging case and charge. Then take earbuds out of the charging case after a few minutes; they will enter pairing mode automatically.

Charging

Earbuds Charging

Put earbuds into the charging case, and they will be charged automatically. The LED indicator will flash green once the earbuds are placed correctly.

Charging Case Charging

Plug the attached Type-C cable into a computer or charger. The green light indicator flashes when the charging case is being charged and will remain solid green after being fully charged.

Battery Status of Charging Case

Note

Please charge the case with a DC5V/1A charger or Computer USB. As the charging and discharging of the earphones increases, the battery performance will decrease, which is normal for all rechargeable batteries. Do not press the contact of the spring pin hard to avoid improper use.

Functional Operation

Music Control

Single-click: Either earbud for ▶️/⏸️.

Double Click: The left earbud for ⏪, the right earbud for ⏩.

Incoming Call Control

Single Click: Either earbud to ?.

Double Click: Either earbud to ❌ (End Call).

Siri Voice Assistant

Long Press 3 seconds: Either earbud to activate Siri voice assistant ?️.

Tips

1. The volume can be adjusted by the phone. Please use the earbuds at a reasonable volume and for a reasonable time, otherwise, it will damage your hearing if you listen to music for a long time at high volume.
2. In Mono mode, double-click the earbud only for the next song.

Specifications

Attention

1. Do not remove or refit earbuds for any reason, otherwise it will lead to headset damage and burn. These are not covered by warranty.
2. Do not touch the earbuds in corrosive liquid, otherwise it will cause serious damage. The Manufacturer will not guarantee the damage caused under this situation.
3. Do not put the equipment under too high or too low temperature (Below 0°C or above 45°C).
4. Please avoid approaching the eyes of children or animals when using equipment lights.
5. Do not use equipment in thunderstorm weather. Thunderstorms may cause abnormal equipment operation and increase the risk of electric shock.
6. Due to the limit of the environment & connection distance for the Bluetooth products, do not use earbuds in environments with large electromagnetic interference and radiation.
7. While driving, try to avoid using earbuds to listen to music, make or receive calls, so as not to distract from danger.

Warning

This product contains a built-in lithium battery. Please do not expose this product to strong sunlight, roasting, or throwing it into the fire, as they may explode.