Trouble Shooting

1. How to set the Alarms Clock?

Setting the alarm

Hold the ALARM button for about 3 seconds to set the alarm time. The display begins to flash. Set the following information in the order listed:

• Hours
• Minutes
• To select individual values, press UP button or the DOWN button and confirm each selection by pressing the ALARM button.
• If you do not make an entry for 20 seconds, setting mode is exited automatically.

Activating/deactivating the alarm

To turn the alarm ON or OFF, press the ALARM button to enter alarm mode, press the ALARM button again to ON or OFF the alarm. The ⏰ symbol should show next to the clock display when alarm mode is active.

Stopping the alarm/snooze function

• When the alarm is triggered, the alarm symbol begins to flash and an alarm sounds.
• By pressing any button (except the SNOOZE/LIGHT) button to stop the alarm. Otherwise, it will stop automatically after 2 minutes.

2. How to turn on the backlight?

Press the SNZ / LIGHT button to activate the backlight for 5 seconds.

3. How to connect remote sensors?

This thermometer is arranged to communicate with three external sensors. One of these comes with the unit, the remaining two are optional.

• Power the thermometer as described in Getting started.
• Set the selector in the outdoor sensor to the desired transmission channel (1, 2, or 3). Automatic data will be transmitted.
• Press the UP button more times to select the channel set on the external sensor. Sequentially selects channel 1, channel 2, channel 3, and sequentially display for 3 channels.

4. Care and maintenance

• Display unit and outdoor sensor must be within 150 ft. (50m) of each other.
• To maximize wireless range, place units away from large metallic items, thick walls, metal surfaces, or other objects that may limit wireless communication.
• To prevent wireless interference, place both units at least 3ft (1 m) away from electronic devices (TV, computer, microwave, radio, etc.).
• To ensure accurate temperature measurement, place units out of direct sunlight and away from any heat sources or vents.
• Do not clean any part of the product with benzene, thinner or other solvent chemicals. When necessary, clean it with a soft cloth.
• Never immerse the product in water. This will damage the product.
• Do not subject the product to extreme force, shock, or fluctuations in temperature or humidity.
• Do not tamper with the internal components.
• Do not dispose of this product as unsorted municipal waste. The collection of such waste separately for special treatment is necessary.

5. Important Placement Guidelines

• Place the weather station away from equipment that generates magnetic fields such as mobile phones, televisions etc.
• In case of non-receipt of the display, signal it is shown the character [signal-indicator]. Press and hold the UP button to receive RF signal.
• Always make sure the channel chosen on the display unit matches the channel option chosen on the outdoor sensor.