Furby Coral: Your Friendship Friend

Getting Started

Battery Info: First Time Furby Setup

To set up your Furby, you will need 4 fresh AA batteries (1.5V AA / LR6). Use a Phillips head screwdriver (not included) to open the battery cover. Insert the batteries, ensuring correct polarity (+ and –), and screw the cover back on. Press the heart gem, and Furby will tell you what to do next!

Important Battery Information: Retain this information for future reference. Batteries should be replaced by an adult. Do not mix old and new batteries, or alkaline with carbon-zinc batteries. Remove batteries if the product will not be used for a long time. Do not short-circuit terminals. Rechargeable batteries should be removed from the product before recharging and recharged under adult supervision. Do not recharge other types of batteries.

Quick Start Guide: Commands You Can Give Furby

Press Furby’s heart gem. Say “Hey Furby!” Wait for Furby to respond. Furby’s ears will glow green and you’ll hear a chime. When the heart gem and ears change to white, Furby is listening. Now you can say one of these commands:

• “Dance Party”: Make Furby's ears light up for 10 minutes!
• “Light Show”: Tap the head to see different color patterns. Touch the tummy for special light effects.
• “Copy Cat”: Furby will wait 6 seconds to hear you say something, then say it back with silly voice effects. Tap the head to change voices and tap the tummy to repeat.
• “Let’s Chill”: Furby will play peaceful music and guide you through calm exercises or cheer you up with positive sayings. Tap on Furby's head to explore different routines.
• “Tell My Fortune”: Ask a question and shake Furby for an answer. (For entertainment purposes only).

Press the heart gem and say “Hey Furby!” again to change modes. Remember to wait for Furby to respond before saying your next command.

You will unlock more phrases, songs, and activities the more you play. Furby will let you know when you've unlocked something!

Helpful Hints

Speak clearly and say only one command at a time. Make sure you are in a quiet place, as Furby reacts to noise and music!

Crystal Ball Mode: Rub the tummy for happy words of wisdom. Shake to switch to Magic Furball mode.

Magic Furball Mode: Ask a question and shake Furby for an answer.

Anatomy of Furby

• Head: Loves to be pet and brushed. Responds to your touch!
• Tummy: See what happens when you tickle and cuddle Furby's tummy.
• Mouth: Feed with your finger or Furby’s favorite pizza charm.
• Feet: Furby may not have arms, but Furby’s feet are always ready for dancing.
• Ears: React to music and speech with lights. Shake Furby to change which color they glow!

Furby Fashion Guide

Make your own friendship bracelet or necklace for Furby or fashions for you! Hair clips can be shared and double as beads too.

Meet Other Friends

When you have 2 or more Furby friends next to each other (sold separately):

1. Choose your “leader” Furby and tap their head once.
2. The “leader” will pair with the other Furby to start the fun!

Each sold separately. Subject to availability.

Furbish Dictionary

Furby speaks their own language! See if you can figure out what Furby is saying.

Power Off

Sleep Mode: Lay Furby down on its back to hear sleep sounds. Wake Up: Press the heart gem or feed Furby!

Full Power Off: Press the heart gem rapidly 3 times.

Tips & Troubleshooting

• Furby won't turn on or doesn't sound right: Try again. Make sure you have fresh batteries. Turn Furby off and back on again.
• I said a command, but Furby won't do it: Wait for Furby to respond to “Hey Furby” before you say the command. It may be too noisy where you are; move to a quieter place.
• Furby’s fur got dirty: Gently wipe it down with a damp cloth, but don't let it get wet! Furby doesn't like water.
• Furby does not respond to Furbish: Ensure you are using the correct Furbish phrases and speaking clearly.
• Full Reset: Turn Furby upside down. Press and hold both the mouth and heart gem at the same time for over 5 seconds. You will see the ears flash red and hear a beep.

Important Information

Furby does NOT connect to the internet or any other devices!

Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.

This product and its batteries must be disposed of separately at your local waste recycling centre. Do not dispose of them in your household waste bin.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Déclaration de la Federal Communications Commission

Cet équipement est conforme à la Section 15 des règlements de la FCC. Son fonctionnement est soumis aux deux conditions suivantes : [1] Cet équipement ne peut causer d’interférence nuisible ; [2] cet équipement doit pouvoir fonctionner même s’il capte de l’interférence, incluant celle pouvant provoquer un fonctionnement indésirable. Cet équipement a été testé et est conforme aux limites d’un instrument numérique de classe B de la Section 15 des règlements de la FCC. Ces limites ont été établies pour assurer une protection raisonnable contre les brouillages préjudiciables dans une installation résidentielle. Cet équipement produit, utilise et peut rayonner des fréquences radioélectriques et, s’il n’est pas monté et utilisé conformément aux instructions, peut créer un brouillage préjudiciable aux radiocommunications. Cependant, ces limites ne garantissent pas qu’il n’y aura pas d’interférence dans une installation particulière. Si ce jouet produit un brouillage préjudiciable aux transmissions télévisuelles ou radiophoniques, ce qui peut se déceler à la mise en marche et à l’arrêt du jouet, l’usager devrait corriger la situation en suivant une ou plusieurs des mesures suivantes : réorienter ou replacer l’antenne de réception ; augmenter la distance entre l’équipement et le récepteur ; demander l’aide d’un marchand ou d’un technicien en radio et télévision. ATTENTION : Toute modification ou altération apportée à cet appareil, sans autorisation expresse de la partie responsable de sa conformité, peut révoquer à l’utilisateur son droit de l’utiliser. CAN ICES-3 (B)/NMB-3(B)