Instruction Manual for Cartell models including: CP-4 Automatic Gate Opener, CP-4, Automatic Gate Opener, Gate Opener, Opener

INSTALLATION INSTRUCTIONS FOR CP-4 AUTOMATIC ...

30 gen 2024 — CP-4 works with all gate operators―powered or solar, single or dual free exit ... • 20 feet away from power pole with a transformer. • 100 feet back from ...


File Info : application/pdf, 2 Pages, 800.41KB

PDF preview unavailable. Download the PDF instead.

cartell-cp4-manual 2020
INSTALLATION INSTRUCTIONS FOR CP-4 AUTOMATIC GATE OPENER

1. SERIAL NUMBER
There is a barcode serial number on the bottom of "puck" and on the product box. When calling to talk about your product, please have this number handy.

PRODUCT CODE

YEAR MADE

SERIAL NUMBER

4. CONNECT TO GATE

CP-4 works with all gate operatorspowered or solar, single or dual free exit terminals.

DUAL EXIT TERMINAL

SINGLE EXIT TERMINAL

RED POWER + RED

POWER +

BLACK WHITE
BLUE YELLOW

POWER  BLACK COMMON WHITE
EXIT N.O. BLUE
EXIT N.C.

GND or COM
FREE EXIT or OPEN
TERMINAL

VOLTAGE 8-24 VAC 8-30 VDC

CURRENT Standby: 30-70 µA Alarm: 40-60 mA

2. TRENCH PIPE & CABLE

· Trench 1/2" PVC pipe to placement of CP-4 · Smooth out entire length of cable before pulling thru PVC pipe · Gently pull cable thru PVC pipe (may need wire lubricant)
12'

80' - 100'

NOTE: Warranty
void if cable not
run in conduit

3. CONDUIT & SLIP JOINT

5. TEST SENSITIVITY
NOTE: IN MOST CASES DO NOT ADJUST SENSITIVITY OR REMOVE LID.

SENSITIVITY ADJUSTMENT

HIGH (Default)
Detects vehicle going 5 MPH 12-14' away 1 & 2 in OFF position

ON 12

MEDIUM
Detects vehicle going 5 MPH 6-8' away 1 ON & 2 OFF position

ON 12

LOW
Detects vehicle going 5 MPH 2-4' away 1 & 2 in ON position

ON 12

NOTE: HIGHEST SENSITIVITY IS WITH DIP SWITCHES IN
THE OFF POSITION
NOTE: DIP SWITCH COLOR MAY VARY

6. BURY CONDUIT & "PUCK"

After pulling cable through plastic conduit, insert conduit inside slip joint on "puck."
DO NOT GLUE (to un-install later, if needed).

Trigger gate by swinging steel over puck (or driving by). If gate opens correctly, bury conduit and puck at least 5" - 8" below surface.
IF ANIMALS TRAMPLING ON TOP OF BURIED PUCK OPEN THE GATE, BURY PUCK DEEPER, PACK DIRT AROUND IT, AND MAKE IT IMMOVABLE.

OTHER INSTRUCTIONS
NOTE: CP-4 IS NOT A SAFETY. YOU MUST ADD EXTERNAL SAFETY WHEN USING CP-4.
· CP-4 may be installed above ground by screwing "puck" directly to an immovable object.
· If installed above ground, use conduit to mechanically protect cable (animals will eat).
· Car should be going at least 5 MPH at sensor to be detected.
Install CP-4 at least: · 6-10 feet away from buried power, telephone, or invisible dog fence · 10 feet away from natural gas lines · 20 feet away from power pole with a transformer · 100 feet back from railroad traffic · 200 feet away from high power substation power lines · 80-100 feet back from gate operator

Technical Specifications

Power Required

8­24 VAC or 8­30 VDC

Stand-By Current

30­70 Microamps (A)

RETURNING MERCHANDISE CONSUMER: Contact your installer

INSTALLER: CALL BEFORE DIGGING UP Call (717) 532-0033, option 1 to troubleshoot and receive a Return Merchandise Authorization (R.M.A.) number. Write R.M.A. number on return shipping box and any correspondence included with defective product.
DISTRIBUTOR: Send installers directly to Cartell, citing 717-532-0033( option 1) as phone number.

5 YEAR WARRANTY

All Cartell products are warranted

Y  WARRA

against defects in material and workmanship for five years. This warranty does not cover defects caused by, but not limited to: acts of God, improper installation,

RANTY 

WARRANT
Y E A R

NTY  WAR

abuse, fire damage, electrical

surges, integrated system failures,

improper lid/gasket installation, overtightening

screws, stripping screw holes, and damage to

cable caused by slicing, pulling, tangling, improper

splicing, and failure to run cable in non-metallic

conduit.

Alarm Current Relay Time

30­40 Milliamps (mA) 2­3 seconds

Relay Contacts Relay Contact
Rating Enclosure Rating
Strength Rating
Temperature Range
Dimensions Weight

SPDT, floating, N.O. or N.C. (Form C)
1 amp/24 VDC (1 mA at 5 VDC min. load)
IP68
9.53 ton-force 8646 kgf
-25° F. ­ +140° F. -32° C. ­ 60° C. 4.5 in. dia. x 2.5 in. high 11.43 cm dia. x 6.35 cm high
5 lbs. (2.7 KG) with 100 ft. cable

CONTACT INFORMATION

TECH SUPPORT

717-532-0033, option 1

RMAs

717-532-0033, option 1

SHIPPING

717-532-0033, option 2

ACCOUNTING

717-532-0033, option 3

INSIDE SALES

717-532-0033, option 4

EMAIL

info@cartell.com

ORDERING (Distributors only)

orders@cartell.com

ADDRESS

510 West King Street Shippensburg, PA 17257

WEBSITE

www.cartell.com

The CP-4 complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTES:

WARNING: This product can expose you to chemicals including Acrylonitrile, which is know to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Copyright © 2020 by Cartell



References

Adobe InDesign 15.0 (Macintosh) Adobe PDF Library 15.0