Philips AVENT Trainer Cup

For your child's safety and health

WARNING!

• Continuous and prolonged sucking of fluids will cause tooth decay.
• Always check food temperature before feeding.
• Throw away at the first signs of damage or weakness.
• Keep components not in use out of the reach of children.
• Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
• Never use feeding teats as a soother.
• Always use this product with adult supervision.

It is not recommended to use a microwave to warm up baby food or drinks. Microwaves may destroy valuable nutrients in food/drinks and may produce localized high temperatures. If you decide to use the microwave, take extra care to stir heated food/drinks to ensure even heat distribution and check the temperature before serving. Only place the container in the microwave, without the screw ring, teat and cap.

Do not allow children to play with small parts or walk/run while using bottles or cups.

Always discard any breast milk that is left over at the end of a feed.

Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness.

❌ Do not use trainer cup parts with glass bottles.

Before first use

Disassemble all parts, clean and then sterilize the parts by placing in boiling water for 5 minutes or sterilize by using a Philips Avent sterilizer. This is to ensure hygiene.

Assembly

Make sure that the feeding teat is fully pulled through the screw ring as shown in the image (Fig. 1, 2).

(Diagram description: Figure 1 and 2 illustrate the correct assembly of the feeding teat through the screw ring.)

Cleaning and storage

Clean all parts before each use to ensure hygiene. After each use, disassemble all parts, wash in warm, soapy water, remove any food residues and rinse thoroughly.

If you use a brush to clean the tip of the feeding teat, clean it as carefully as possible to avoid damage.

Then sterilize using a Philips Avent sterilizer or boil for 5 minutes.

Make sure that you wash your hands thoroughly and that the surfaces are clean before contact with sterilized components.

During sterilization with boiling water, prevent the parts from touching the side of the pot. This can cause irreversible product deformation, defect or damage that Philips cannot be held liable for.

Food colorings may discolor parts.

This product is dishwasher safe.

Do not place the product in a heated oven.

Do not bring the cup parts in contact with or place on surfaces with abrasive or antibacterial cleaning agents.

We recommend replacing feeding teats every 3 months.

Keep feeding teats in a dry, covered container.

Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant (sterilizing solution) for longer than recommended, as this may weaken the teat.

Compatibility

Replacement teats are available separately.

To learn more about choosing the right teat for your baby, visit us at www.philips.com/avent.

These cup parts are compatible only with Philips Avent Natural teats.

Support

If you need information or support, please visit www.philips.com/support.