SUNMI T6F0A/T6F0B Smart POS System

Product Overview

The SUNMI T6F0A/T6F0B is a Smart POS System designed for industry applications such as express delivery, logistics, retail, and catering. It functions as a hardware and system interface carrier, requiring specific APK installations for various operational scenarios.

Device Components and Features

Safety Information

Safety Warnings

Please insert the AC plug into the AC socket corresponding to the input marked on the power adapter.

This is a Class B product. In a residential environment, this product may cause radio interference. In such cases, the user may need to take practical measures to address the interference.

Do not operate the device in non-safe areas.

Do not charge the device in dangerous places.

Battery Replacement:

• There is a risk of explosion if the battery is replaced by an incorrect type!
• The old battery shall be given to maintenance personnel for disposal. Do not throw it into fire!

Do not replace the battery when explosive gas may be present.

Important Safety Instructions

• Please avoid installation or usage during thunderstorms to prevent the risk of being struck by lightning.
• Please disconnect the power immediately once you find any abnormal odors, overheating, or smoke.
• Do not use the device under extreme cold or hot environments, such as conditions near fire or lit cigarettes.
• Do not throw, drop, or bend the device.
• Try to use the device in a clean and dust-free condition to avoid small items falling into the terminal.
• Do not use the device near medical equipment without permission.
• This device is only suitable for safe use in areas with an altitude of 5000m and below.
• Before storing your device for an extended period, please charge the battery to the optimal level to prevent deep discharge. For instance, if you plan to store the device for more than six months, it's recommended to charge it to 50% of its capacity every six months.

Battery Safety

Charge the battery only at ambient temperatures ranging from 0°C to 45°C.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or an equivalent type of battery recommended by the manufacturer.

Dispose of used batteries according to the battery manufacturer’s instructions.

RF Exposure Statement (SAR)

This device has been tested and meets EU, FCC, and IC RSS-102 applicable limits for radio frequency (RF) exposure. Please visit: www.sunmi.com.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The end-user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The portable device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg for body/head and 4 W/kg for extremity, averaged over one gram of tissue. The minimum separation distance for body-worn accessories is 10mm, and for extremity is 0mm.

The product SAR limit for Europe is 2.0 W/kg (10g) for head and 4.0 W/kg (10g) for limb-worn. The SUNMI Smart POS System (Model: T6F0A/T6F0B) has been tested against this SAR limit. The highest SAR value reported during product certification when properly worn on the body (5mm) is 1.25 W/kg, for the head (0mm) is 0.24 W/kg, and for limbs (0mm) is 2.22 W/kg.

French translation of SAR statement: Cet équipement a été testé et respecte les limites applicables pour l'exposition aux radiofréquences (RF). Les limites de DAS dépendent de l'utilisation de cet équipement contre la tête ou la main. La limite de DAS IC pour les extrémités est de 4,0 W/kg (10 g) et la limite de DAS pour la tête est de 1,6 W/kg (1 g). La valeur de DAS la plus élevée rapportée selon cette norme lors de la certification du produit en mode tenu à la main est de 1,08 W/kg pour les extrémités (10 mm) et de 0,47 W/kg pour la tête (0 mm).

Regulatory Conformance

EU Regulatory Conformance

Conformity CE: Shanghai Sunmi Technology Co., Ltd. declares that this device complies with the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: https://developer.sunmi.com/docs/read/en-US/maaeghjk480.

Product can be operated in at least one Member State without infringing applicable requirements of the use of radio spectrum (RED article 10.2).

Restrictions of Use

Operation of 5150-5350MHz is restricted to indoor use only in all EU and UK member states.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

ISED Canada Compliance Statements

This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

French translation: Le présent appareil est conforme aux CNR d'ISDE Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L’appareil ne doit pas produire de brouillage, et (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Devices operating in the band 5150-5250 MHz are reserved only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.

French translation: Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.

WEEE Recycling

This symbol ♻️ means that it is forbidden to dispose of the product with normal household waste. At the end of the product life cycle, waste equipment should be taken to designated collection points, returned to the distributor when purchasing a new product, or contact your local authority representative for detailed information on WEEE recycling.

Technical Specifications

Laser light exit port: There is laser light from the scanner, Class 2 laser product, please do not stare into beam.

Pre-installed Software

The device comes with the following pre-installed software:

• SUNMI App Store
• Launcher
• Function Keys Customization
• BaseService
• Customization Service (Wallpaper, Boot Animation)
• Developer Guidance (Testing Assistant)
• User Guide
• Startup Guide
• Remote Assistance
• SUNMI OTA

To check software details, navigate to "Settings > Applications" and select the corresponding software name to view information. To uninstall software, select "Settings > Applications > Manage Applications > Uninstall" or long-press on the icon and drag it to the "Recycle Bin".

Statements and Disclaimer

Statements

The company is not responsible for the following actions:

• Damage caused by use and maintenance without the conditions described in this guide.
• Damages or problems caused by alternatives or consumables not provided or approved by the company. Unauthorized product modifications or changes are prohibited.
• The operating system of this product supports official system updates. If the user flashes a third-party ROM system or modifies the system files using cracking methods, it may cause system instability as well as pose security risks and threats.

Disclaimer

Due to product updates, some details of this document may not match the product. Please refer to the actual product. The right to interpret this document belongs to the company. The right to modify this guide without prior notice is reserved.

Product Warranty Card Summary

Product Name: Smart POS System

Product Model: T6F0A/T6F0B

Warranty Period: The company provides [Number] days of warranty service from the date of purchase.

Warranty Exclusions: Free warranty is not provided under the following circumstances:

• Products that have been disassembled or repaired without permission.
• Product barcodes, fragile stickers are damaged, or the warranty card is altered or incomplete.
• Faults caused by not operating the equipment according to the instructions in the manual.
• Man-made damage caused by water ingress, drops, scratches, or breakage.
• Faults or damage caused by force majeure.
• Outside the warranty period.

Contact Information:

Company Address: Room 505, No. 388 Song Hu Road, Yang Pu District, Shanghai, China

Contact Phone: 400-6666-509

EU Representative: SUNMI France SAS, 186, avenue Thiers, 69006 Lyon, France

Product Toxic and Hazardous Substances Information

○: Indicates that the content of the toxic or hazardous substance in all homogeneous materials of this component is below the limit specified in SJ/T11363-2006.

X: Indicates that the content of the toxic or hazardous substance in at least one homogeneous material of this component exceeds the limit specified in SJ/T11363-2006; however, for components marked with "X", the content exceeds the limit because there is currently no mature alternative technology available in the industry.

Products that reach or exceed the environmental protection use period should be recycled and reused according to the "Measures for the Administration of the Control of the Control of Electronic Information Products", and should not be discarded arbitrarily.

Network Access Warning (Chinese Content Summary)

Operating System: Only supports official upgrades. Users who flash unofficial systems are responsible for any security risks and losses.

Device Purpose: The device is intended for industries like express delivery, logistics, retail, and catering. It acts as a hardware and system interface carrier, requiring the installation of corresponding APKs for specific functions.

NFC Functionality: Complies with regulations for micro-power short-range radio transmitting devices. NFC antenna is built-in. Users can enable/disable NFC via "Settings > Connected Devices > Connection Preference Settings > NFC".

Usage Restrictions: Do not alter usage scenarios or conditions, expand frequency range, increase transmit power, or change antennas without authorization. Avoid causing harmful interference to other legal radio stations and do not claim immunity from interference. Must tolerate interference from ISM equipment or other legal radio stations. If harmful interference occurs, stop use immediately and take corrective measures. Follow electromagnetic environmental protection regulations when using in designated areas (e.g., near airports). Prohibited to use remote control models within a 5000-meter radius of an airport runway center point. NFC function operates normally at room temperature and is powered by the adapter and battery.