Costway CM24319 Artificial Christmas Tree Assembly Instructions

Important Safety Information

This instruction booklet contains important safety information. Please read and keep for future reference.

⚠️ Warning:

• There are plastic caps on the end of the poles to protect them during shipping. Please ensure these are removed before assembling.
• If a cap is broken or missing, do not worry.

Snow Falling Notice:

The flocking craft uses a synthetic dust or powder to create a freshly-fallen snow effect on the Christmas tree. Some snow may fall during setup. It is advised to set up the tree outdoors or place a mat on the ground to avoid dust in the room and to facilitate cleaning the tree once it is installed.

Assembly Instructions for Christmas Tree

Assembly Details: [One Person Assembly] | [Approx. 10 Min Assembly]

Components:

• ① Tree Top
• ②③ Tree Body
• ④ Metal Stand

Parts Included:

• [Screws: 3 pcs]
• [Protective Cap] (for poles)

Steps:

1. Open the metal stand in the shape of an "X".
2. Set the screws into the holes of the metal stand.
3. Remove packing material from the ends of the poles. Insert the bottom tree body (③) into the center of the metal stand.
4. Tighten the screws of the stand, keeping the tree body upright.
5. Insert the upper tree body (②) and push down the branches into the bottom tree body.
6. Insert the tree top (①).
7. Unfold all the leaves of the tree. Repeat this for each layer towards the tree top. Shape each tip upward for a natural appearance.
8. Assembly is fully complete. The tree is ready to decorate and enjoy!

Note: The amount of accessories depends on the height of the Christmas tree. The goods are subject to the real thing.

Assembly Instructions for LED Lighting Christmas Tree

Note: The installation steps from step 2 to 8 are the same as the above tree.

Components:

• ① Tree Top
• ②③ Tree Body
• ④ Metal Stand
• ⑤ Connecting Line and Transformer

Steps:

9. Get the separated connecting line and transformer from the carton.
10. Insert the joint part.
11. Find the joint part with the red rope in the tree.
12. Connect all the joint parts of the tree body with the connecting line.
13. Electrify the light and enjoy the lighting romance.

CAUTION:

• Firmly secure all screws before use.
• Product is intended for indoor use only.
• Do not place the tree in a wet location.
• Seasonal products are not intended for permanent installation or use.
• If any part is missing, broken, damaged, or worn, stop using the item until repairs are made or replacement parts are installed.
• Do not use the item in a way that is inconsistent with the manufacturer's instructions.

Return / Damage Claim Instructions

General Guidelines:

• DO NOT discard the box / original packaging. In case of a return, the item must be returned in its original box.
• Take a photo of the box markings (text on the side) for part identification if needed.
• Take a photo of the damaged part (if applicable) to file a claim.
• Send an email with the requested images and a description of your claim directly from the marketplace where the item was purchased.