RM-ZN-T1
Vendor: ZYXEL NETWORKS
Product Specifications
Supported Models
- USG Flex 100
- USG Flex 100AX
- USG Flex 100H
- USG Flex 100HP
- USG Flex 100W
- USG Flex 50
- USG Flex 50AX
- USG Flex 50H
- USG Flex 50HP
Color
SILVER
Dimensions
(HxWxD): 44 x 483 x 217 mm
1.73 x 19.00 x 8.54 inch
Mounting Instructions
- Unscrew the middle screw on the back of the appliance.
- Slide your appliance through the front of the rack and secure it with one bolt.
- Place the power supply on the rack and secure with two zip ties.
- Connect the power supply to the appliance and tie down the excess length to the rack with one zip tie.
- Connect the appliance to the keystones using the supplied cables.
- Tie the cables together using the Velcro strap.
Please ensure proper ventilation according to the network appliance manufacturer's guidelines.
Package Contents
- 1 x Rackmount kit
- 1 x Bolt
- 3 x Zip ties
- 9 x Cat 6 cables
- 2 x Velcro straps
Appliance not included.
Visual Description
The image displays a rackmount setup featuring Zyxel USG Flex network appliances. The top of the image shows a Zyxel USG Flex device mounted in a rack, connected via Ethernet cables to a patch panel. Below it, another, smaller Zyxel USG Flex appliance is installed on a lower rack shelf. Both appliances are connected using Ethernet cables, which are organized and secured with zip ties and Velcro straps. A power supply unit is also visible, fastened to the rack with zip ties, indicating a clean and organized installation.
Environmental Consideration
♻️ CONSIDER THE ENVIRONMENT, RECYCLE WHERE APPLICABLE
Questions
Email support@rackmount.it or contact your reseller.
Install Guide - 25-06-2025
