JASTIP V15 Quick Start Guide

Installing Desired Cleaning Accessory

To attach a cleaning accessory, align the accessory with the main unit and push until it clicks into place. To detach, press the release button and pull.

Diagram Description: Illustrates the process of connecting and disconnecting various cleaning accessories to the main body of the vacuum cleaner, with 'Click' indicators showing secure attachment points.

Power mode and speed switch

The vacuum starts in 'MID' mode. Touch the 'UP' button to switch to 'MAX' mode. Touch the 'UP' button again to switch to 'MIN' mode.

Diagram Description: Shows the handle of the vacuum cleaner with the 'ON/OFF button' and 'Switch Button'. A digital display shows the current power mode ('MID', 'MAX', 'MIN') and battery percentage. The display indicates that touching the 'UP' key cycles through the modes.

Recharging and Power Display

Recharging on the storage wall-mount: Attach the vacuum to the wall-mount for charging.

Charging separately: Connect the charger directly to the vacuum's charging port.

Power display: The digital display shows the battery percentage and charging status (e.g., 'Fully charged', 'Charging from low', 'Charging, medium charge').

Diagram Description: Depicts two methods of charging the vacuum: using a wall-mounted dock and charging directly with the adapter. The power display section shows different battery level indicators.

Empty the dust bin

1. Press the release button on the dust bin and pull it away from the main unit.
2. Press the dust bin cover release button to open the cover and empty the contents.
3. Close the dust bin cover.
4. Attach the dust bin back to the main unit.

Diagram Description: A step-by-step visual guide showing how to detach the dust bin, open its lid to empty debris, and reattach it to the vacuum cleaner. The 'MAX' fill line is indicated.

Clean the Electric Floor Brush

Warning: Ensure the vacuum is switched off before cleaning the floor brush. Avoid contact with water for the electronic components.

1. Detach the floor brush from the main unit.
2. Remove any tangled hair or debris from the brush.
3. If necessary, wash the brush with cold water.
4. Allow the brush to air dry completely for at least 24 hours before reattaching.

Diagram Description: Shows the floor brush being detached, cleaned of debris, washed under running water, and then left to dry in the sun for 24 hours.

Dust Cup Cleaning

Important: Wash filters with cold water at least every month. Ensure filters are completely dry before refitting.

1. Detach the dust cup and filter assembly.
2. Wash the filters with cold water.
3. Allow filters to dry completely for at least 24 hours.
4. Reassemble the dust cup and filters.

Diagram Description: Illustrates the process of removing the dust cup and its filters, washing the filters, drying them for 24 hours, and then reassembling them. Warnings are shown against using hot water or not allowing sufficient drying time.

Remove the Dust Cup

Press the release button to detach the dust cup. The main tube can also be detached for cleaning or storage.

Diagram Description: Shows how to remove the dust cup and the main extension tube from the vacuum cleaner.

Prohibited operations

• Do not use the V15 near open flames.
• Do not store the V15 near heat sources.
• Do not put hands near the brush bar when the V15 is running.
• Not applicable for picking up liquids.
• Not applicable for picking up burning objects.

Diagram Description: A series of icons depicting prohibited actions: vacuum near flames, vacuum near heat sources, hands near the running brush, picking up liquids, and picking up burning objects.