Super Bright LEDs RSL-Series Recessed LED Step Lights
User Manual
Important: Read all instructions prior to installation.
Included Parts
- 1 - Step light
- 1 - Wire pigtail
Safety and Notes
- This product should be installed and serviced in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- When interconnected, each six-light accessory harness will support five lights each instead of six, as the last connector will be used to connect to the next harness.
Specifications
| Model | Operating Temperature | IP Rating |
|---|---|---|
| RSL-x | -4°F - 122°F (-20°C - 50°C) | IP65 |
Optional Accessories
- RSL-6S - Six-light wire harness for single-color light
- RSL-S2M - 6.6 ft (2 m) extension harness for single-color light
- RSL-6RGB - Six-light wire harness for RGB lights
- RSL-RGB3M - 9.8 ft (3 m) extension harness for single RGB light
Installation
- Mark and drill a 5/8" hole in the mounting surface.
- Make the electrical connection.
- Test fit the light. If needed, apply silicone adhesive to assist in securing the light.
Dimensional Drawings
RSL-40K1-S shown (dimensions represent all models)
The RSL-Series step light has a circular face with a diameter of approximately 1.14 inches (28.95 mm). The main body of the light, which is recessed, has a diameter of approximately 0.63 inches (15.94 mm). The wire pigtail extends approximately 7.52 inches (190.96 mm) from the light body, with a total harness length of approximately 46.79 inches (1188.36 mm).
The RSL-6S and RSL-6RGB wire harness has a total length of approximately 10 ft (3048 mm). It features multiple connectors spaced approximately 17.50 inches (444.50 mm) apart. Each connector is approximately 1.42 inches (36.07 mm) from its end, and the final pigtail connector is approximately 1.39 inches (35.39 mm) from its end.
The RSL-RGB3M extension harness is approximately 10 ft (3048 mm) long. It has a total length of approximately 117.19 inches (2976.62 mm) between the main connectors. The end connectors are approximately 1.42 inches (36.07 mm) and 1.39 inches (35.39 mm) from their respective ends.
The RSL-S2M extension harness is approximately 10 ft (3048 mm) long. It has a total length of approximately 79 inches (2006.6 mm) between the main connectors, with the active section being approximately 76.19 inches (1935.22 mm). The end connectors are approximately 1.42 inches (36.07 mm) and 1.39 inches (35.39 mm) from their respective ends.
