INSTALLATION INSTRUCTIONS

Step 1: Detach Front Module

[Press tab to detach]

Detach the front module from the back plate by pressing the tab located at the top and bottom of the control casing.

Step 2: Route Wires and Mount Back Plate

[Routing the wires]

Guide the signal wires (4) through the central opening of the back plate. Mount this plate to either a standard electrical device box or directly to the wall using screws. If required, use wall anchors.

NOTE: Be sure the screws are secure but do not over tighten. This may result in damage to the back plate.

Step 3: Connect Wires to Terminal Block

[Terminal block (front module backside)]

Insert the wires (4) into the terminal block, located on the backside of the front module. Secure them in place by tightening the terminal screws using a small [3.0mm flat head screwdriver] (not included).

NOTE: For each wire, take note of the wire color chosen and connect to the corresponding terminals for the control and the HRV/ERV. See illustration below.

Terminal connections: B, A, D+

Step 4: Attach Front Module

Attach the front module to the mounted back plate. First, hook the top of the front module to the top clips of the back plate, then press the bottom of the front module until you hear a 'click'. Ensure the ventilation system operates correctly.

NOTE: Be careful not to pinch or trap the wires when attaching the front module to the back plate.

Step 5: Provide Operating Instructions

Leave operating instructions with the homeowner.