Fortress SS1180
Base Fixing Instructions & Guarantee Registration
Multilingual Instructions
- ?? BASE FIXING INSTRUCTIONS & GUARANTEE REGISTRATION
- ?? LA NOTICE DE FONCTIONEMENT & GARANTIE
- ?? ISTRUZIONI USO CHIUSURA & REGISTRAZIONE DELLA GARANZIA
- ?? BEDIENUNGSANLEITUNG & GARANTIEKARTE
- ?? CERRADURAS & GARANTÍA
Phoenix Safe Co. Ltd. Liverpool
Where peace of mind is guaranteed.
Certifications: ECB-S, Secured by Design, MLA, Eurosafe
Product Information
Thank you for purchasing a Phoenix Safe.
Guarantee Registration
Please submit your guarantee registration by visiting our website www.phoenixsafe.com and clicking on "Register Safe".
Opening the Safe
- Key Locking Safe: Please insert one of the two keys supplied into the keyhole and turn clockwise, then pull the door to open.
- Electronic Locking Safe: Please see the operating manual provided separately for opening your electronic locking safe.
Base Fixing
To base fix your safe, use the following instructions.
Choosing a Place to Install Your Safe
- Look for a place that does not restrict access and the swing of the door.
- Ensure that the floor is level.
- For best results, a concrete floor is preferable.
- Using a pencil, mark through the fixing holes.
Support
Website: www.phoenixsafe.co.uk
Email: info@phoenixsafe.co.uk
Phone: +44 (0) 151 944 6444
Base Fixing Instructions
Supplied in Box
- M12 x 140mm Anchor Bolt
- M12 x 140mm Anchor Bolt
- Bullone M12 x 140mm
- M12 x 140mm Verankerungsbolzen
- M12 x 140mm Perno de Anclaje
You Will Require
- Socket Wrench / Clé à douille / Chiave a bussola / Steckschlüssel / Llave de Tubo
- Brush / Une brosse / Spazzolino / Bohrlochreinigungsbürste / Cepillo
- Hammer / Un marteau / Martello / Hammer / Martillo
- 12mm Drillbit / Une mèche de 12mm / Punta 12mm / Bohrer 12mm / Broca de 12mm
- Drill / Une perceuse / Trapano / Akkubohrer / Taladradora
Steps for Base Fixing
- Drill Hole: Drill a 120mm deep hole with a 12mm drillbit.
- Clean Hole: Remove debris with the brush.
- Insert Anchor Bolt: Insert anchor bolt and tap down with a hammer.
- Tighten Bolt: Screw anchor bolt until fully tightened.
ECB-S Certificate
The European Certification Body GmbH accredited according to ISO/IEC 17065 awards to Phoenix Safe Co. Ltd. the right to carry the ECB S certification mark for Secure safe cabinets of security level S2 according to EN 14450:2005 and ECB S C10 (clause 3.1.11).
Certificate Number: 1407/SSC14-02A
Valid From: 15 December 2017
Valid Until: 31 October 2021
Issued By: European Certification Body GmbH, Frankfurt am Main, Germany
