Infinix HOT 6 Quick Guide

Declaration of Compliance

Hereby, INFINIX MOBILITY LIMITED declares that this Mobile Phone is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

Know Your Phone

The Infinix HOT 6 features the following external components:

• 1. Earphone jack
• 2. Front camera
• 3. Camera
• 4. Volume button
• 5. Power button
• 6. USB port
• 7. Front flash
• 8. Rear flash
• 9. Fingerprint sensor

Visual representation shows the front, back, and side views of the phone with numbered indicators pointing to these components.

Getting Started: Inserting SIM and Memory Card

1. Insert the tray into the SIM card slots next to the pinhole.
2. Place SIM cards face down and align them with the tray opening.
3. Insert them correctly into the phone's SIM card slots.

Charging the Phone

You can charge your device using a charger or by connecting it to a computer via a USB cable (provided with the phone).

Note: Use only a compatible charger. The battery is built-in and non-removable.

To restart the phone, press and hold the power button for 10 seconds.

Illustration shows the bottom of the phone with the USB port and speaker grille.

Important Safety Information

• Use earphones and headphones with caution to avoid hearing loss from excessive sound pressure.
• There is a risk of explosion if the battery is replaced with an incorrect type. Dispose of used batteries according to instructions.
• The product should only be connected to a USB interface of version USB2.0.
• Adapters should be installed near the equipment and be easily accessible.
• Operating Temperature Range (EUT): -10°C to +65°C.
• Charging Temperature Range: 0°C to +55°C.
• Adapter Specifications:
  • Adapter 1: XCU32 (Input: 100~240V 50/60Hz 500mA, Output: 5.0V 2.0A)
  • Adapter 2: CU-60YX (Input: 100~240V 50/60Hz 400mA, Output: 5.0V 2.0A)
• The device complies with RF specifications when used at 5mm from your body.
• To prevent possible hearing damage, do not listen at high volume levels for long periods.
• Earphone and USB cables are shielded.

RF Specifications

Operating Frequency Band (RF)

• E-GSM900: 880-915MHz (TX), 925-960MHz (RX)
• DCS1800: 1710-1785 MHz (TX), 1805-1880 MHz (RX)
• WCDMA BAND I: 1920-1980 MHz (TX), 2110 - 2170 MHz (RX)
• WCDMA BAND VIII: 880-915MHz (TX), 925- 960MHz (RX)
• Bluetooth: 2400 -2483.5 MHz (TX/RX)
• WiFi: 2412-2472 MHz (TX/RX)
• GPS: 1.57542GHz
• FM: 87.5 MHz - 108 MHz

Modulation Mode

• GMSK, 8PSK (GSM)
• BPSK, QPSK (WCDMA)
• GFSK, π/4- DQPSK, 8DPSK (BT)
• GFSK (BLE)
• CCK for IEEE 802.11b (WiFi)
• OFDM for IEEE 802.11g/n (HT-20)/HT-40 (WiFi)
• BPSK (GPS)

RF Output Power

• GSM900: 33dBm±2dB
• GSM1800: 30dBm±2dB
• WCDMA BAND I/VIII: 24dBm+1.7dB/-3.7dB
• Bluetooth: 0-10 dBm
• WiFi: 14dBm +/-3dB

Specific Absorption Rate (SAR) Certification

THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO WAVES

DOC information available on the Internet: www.infinixmobility.com

[Recycling symbol indicating WEEE compliance]

Declaration of Conformity

Manufacturer: INFINIX MOBILITY LIMITED

Address: RMS 05-15, 13A/F SOUTH TOWER WORLD FINANCE CTR HARBOUR CITY 17 CANTON RD TST KLN HONG KONG.

Declare under their own responsibility that the product:

Product name: Mobile phone

Model Numbers: X606D, X606C

Trademark: Infinix

conforms with the relevant standards or other standardising documents, including:

Health:

• EN 50360:2017
• EN 50566:2017
• EN 62479:2010

Safety:

• EN60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013

EMC:

• Draft ETSI EN 301 489-1 V2.2.0 (2017-03)
• Draft ETSI EN 301 489-17 V3.2.0 (2017-03)
• Draft ETSI EN 301 489-19 V2.1.0 (2017-03)
• Draft ETSI EN 301 489-52 V1.1.0 (2016-11)

Other Standards:

• EN 55032:2015
• EN 55035:2017
• EN61000-3-2:2014
• EN61000-3-3:2013

Radio:

• ETSI EN 301 511 V12.5.1 (2017-03)
• ETSI EN 301 908-1 V11.1.1 (2016-07)
• ETSI EN 301 908-2 V11.1.1 (2016-07)
• ETSI EN 300 328 V2.1.1 (2016-11)
• ETSI EN 303 413 V1.1.1 (2017-06)
• Final Draft ETSI EN 303 345 V1.1.7(2017-03)

Software Version: X606C-H8023CE-O-180424V2

Hardware Version: V1.3

Adapter 1: XCU32 (Input: 100-240V~50/60Hz 500mA, Output: 5.0V 2.0A)

Adapter 2: CU-60YX (Input: 100-240V~50/60Hz 400mA, Output: 5.0V 2.0A)

Li-ion battery: BL-39HX (Voltage: 3.85V, Capacity: 3900mAh/4000mAh(min/typ))

Limited Charge Voltage: 4.4V

Notified body involved: TÜV Rheinland LGA Products GmbH, 0197.

Conformity assessment performed according to Directive Annex III Module B of the 2014/53/EU Radio Equipment Directive (RED) and issued the EU-type examination certificate.

This declaration of conformity is issued under the sole responsibility of the manufacturer.

The object of the declaration described above is in conformity with the relevant Union harmonisation legislation: Directive 2014/53/EU.

Place and date of issue (of this DoC): Shenzhen/2018-5-8

Person responsible: Lebin, Xie/Manager