Xiaomi Mi MIX 3 Quick Start Guide

Getting Started

Long press the power button to turn on the device. Follow the on-screen instructions to configure your device.

For more information, visit the official website: www.mi.com.

MIUI

The Mi MIX 3 comes pre-installed with MIUI, a customized Android-based operating system that offers frequent updates and user-friendly features suggested by over 200 million active users worldwide. For more information, please visit www.miui.com.

Device Overview

The device features the following key components:

• AI Button
• Volume Buttons
• Power Button
• USB Type-C Port

SIM Card Tray

The device supports dual Nano-SIM cards.

• Nano-SIM
• Nano-SIM

Dual SIM Information

Dual 4G SIM requires support from your local telecom operator and may not be available in all regions. Supports dual nano-SIM cards. When using both SIM card slots, either card can be set as the primary card. Only certain regions and telecom operators support VoLTE. System updates may be applied when network optimization occurs. For details, please refer to the system version in use on the device.

Environmental Disposal

Please dispose of this product correctly. This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle responsibly to promote the sustainable reuse of material resources. To safely recycle your device, please use return and collection systems or contact the retailer where the device was originally purchased.

For Environment Declaration, please refer to the link: http://www.mi.com/en/about/environment/

Important Safety Information

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

For more important safety information, please refer to the User Manual at: http://www.mi.com/en/certification/

Read all the safety information below before using your device. Using unauthorized cables, power adapters, or batteries can cause fire, explosion, or pose other risks. Use only authorized accessories compatible with your device.

The operating temperature range for this device is 0°C to 40°C. Using the device outside this temperature range may damage it.

If your device has a built-in battery, do not attempt to replace it yourself to avoid damaging the battery or the device.

Charge this device only with the included or authorized cable and power adapter. Using other adapters may cause fire, electric shock, and damage to the device and adapter.

After charging is complete, disconnect the adapter from both the device and the power outlet. Do not charge the device for longer than 12 hours.

The battery must be recycled or disposed of separately from household waste. Mishandling the battery may cause fire or explosion. Dispose or recycle the device, its battery, and accessories according to local regulations.

Do not disassemble, hit, crush, or burn the battery. In case of deformation, stop using the battery immediately.

• Do not short-circuit the battery to avoid overheating, burns, or other personal injuries.
• Do not place the battery in high-temperature environments. Overheating may cause explosion.
• Do not disassemble, hit, or crush the battery to avoid battery leaks, overheating, or explosion.
• Do not burn the battery to avoid fire or explosion.
• In case of deformation, stop using the battery immediately.

Keep your device dry. Do not attempt to repair the device yourself. If any part of the device does not work properly, contact Mi customer support or bring your device to an authorized repair center.

Connect other devices according to their instruction manuals. Do not connect incompatible devices to this device.

For AC/DC Adapters, the socket-outlet shall be installed near the equipment and shall be easily accessible.

Safety Precautions

Observe all laws and rules that restrict the use of mobile phones in specific cases and environments. Do not use your phone in petrol stations, explosive atmospheres, and potentially explosive environments, including fueling areas, below decks on boats, fuel or chemical transfer or storage facilities, and areas where the air contains chemicals or particles, such as grain, dust, or metal powders. Obey all posted signs to turn off wireless devices such as your phone or other radio equipment.

Turn off your mobile phone or wireless device when in a blasting area or in areas posted to turn off "two-way radios" or "electronic devices" to avoid interfering with blasting operations.

Do not use your phone in hospital operating rooms, emergency rooms, or intensive care units. Comply with the current rules and regulations of hospitals and health centers.

Please consult your doctor and the device manufacturer to determine if operation of your phone may interfere with the operation of your medical device. To avoid potential interference with a pacemaker, maintain a minimum separation of 15 cm between the mobile phone and the pacemaker. Use the phone on the opposite ear to your pacemaker and do not carry it in a breast pocket.

Do not use your phone near hearing aids, cochlear implants, etc., to avoid interference with medical equipment.

Respect aircraft safety regulations and turn off your phone on board the aircraft when required.

When driving a vehicle, use your phone in accordance with relevant traffic laws and regulations.

To avoid lightning strike, do not use your phone outdoors during thunderstorms.

Do not use your phone to make calls while it is charging.

Do not use your phones in places with high humidity such as bathrooms. Doing so may result in electric shock, injury, fire, and charger damage.

Security Notice

Update your phone's operating system using the built-in software update feature, or visit our authorized service outlets. Updating software through other means may damage the device or result in data loss, security issues, and other risks.

EU Regulations

RED Declaration of Conformity

Xiaomi Communications Co., Ltd. hereby declares that this GSM/GPRS/EDGE/UMTS/LTE Digital Mobile Phone with Bluetooth and WiFi M1810E5A is in compliance with the essential requirements and other relevant provisions of the RE Directive 2014/53/EU.

The full text of the EU declaration of conformity can be consulted at www.mi.com/en/certification.

SAR Information

Body-worn SAR testing has been carried out at a separation distance of 5 mm. To meet RF exposure guidelines during body-worn operation, the device should be positioned at least this distance away from the body. If you are not using an approved accessory, ensure that whatever products used are free of any metal and that they position the phone with the indicated distance away from the body.

Legal Information

This device may be operated in all member states of the EU. Observe national and local regulations where the device is used.

This device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range in the following countries: AT, BE, BG, HR, CY, CZ, DK, EE, FI, FR, DE, EL, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, RO, SK, SI, ES, SE, UK.

Ensure the power adapter used meets the requirements of Clause 2.5 in IEC60950-1/EN60950-1 and has been tested and approved according to national or local standards.

Manufacturer: The Rainbow City of China Resources, NO.68, Qinghe Middle Street, Haidian District, Beijing, China 100085

Frequency Bands and Power

This mobile phone offers the following frequency bands in EU areas only and maximum radio-frequency power:

• GSM 900: 35 dBm
• GSM 1800: 32 dBm
• UMTS band 1/3/8: 25 dBm
• LTE band 1/3/7/8/20/28/34/38/40: 25.7 dBm
• Bluetooth: 20 dBm
• Wi-Fi 2.4 GHz band: 20 dBm
• Wi-Fi 5 GHz band: 20 dBm
• NFC: 13.56MHz < -6.05 dBuA/m at 10m

E-label

This device has an electronic label for certification information. To access it, please select Settings > About Phone > Certification or select Settings, then type "Certification" into the search bar.

SAR Information

SAR 10g limit: 2.0W/Kg, SAR Value: Head: 1.448 W/Kg, Body: 1.568 W/Kg (5mm distance).

Temperature

Temperature: 0 °C - 40 °C

Model Information

Model: M1810E5A. The number 1810 indicates the date of putting the product on the market is 201810.

Printing Specifications

Paper: Jindong Taikongshuo 105g matte copper, front and back matte oil. Size: 240x65mm (single page 120x65mm). Binding method: Saddle stitching. Color: Pantone Cool Gray 8C.