Philips Dynalite DDNG-KNX KNX Network Gateway
Installation Instructions
Important Safety Information
⚠ Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Product Overview and Specifications
The Philips Dynalite DDNG-KNX is a KNX Network Gateway designed for lighting control systems.
Dimensions:
Width: 59 mm (2.32 in)
Height: 95 mm (3.74 in)
Depth: 105 mm (4.13 in)
Mounting Hole Spacing (Horizontal): 75 mm (2.95 in)
Mounting Hole Spacing (Vertical): 45 mm (1.77 in)
Environmental Conditions:
IEC Pollution Degree: II
Operating Temperature: 0°C to 40°C (32°F to 104°F)
Operating Humidity: ≤90% (non-condensing)
Connection Terminals and Wiring
The gateway features several connection terminals for system integration:
Internal Connections (Diagram 2):
- Microprocessor (μP):
- SHLD: Shield connection
- GND: Ground
- DyNet D+: DyNet Data Plus
- DyNet D-: DyNet Data Minus
- +12V: 12V Power Supply (draws ≤15 mA)
- AUX/UL924: Auxiliary/UL924 connection
KNX Port:
- + : KNX Power Plus
- - : KNX Power Minus
- (KNX operates at 21-30 V, ≤10 mA)
Wiring Specifications (Diagram 3, 5, 6):
For KNX and RS-485 DyNet connections, use cables with a cross-sectional area of 0.3-2.5 mm² (22-12 AWG).
Ensure a torque of 0.4 Nm (3.5 Lb-in) when securing wires.
The maximum recommended cable length for RS-485 DyNet is <20 meters.
Service Switches (Diagram 4):
The device includes service switches and LEDs:
- SERVICE LED SW: Service switch for LED status
- SERVICE SW LED: Service switch for general function
These switches can be set to positions 0 or 1.
System Integration (Diagram 5):
The gateway connects to both KNX and RS-485 DyNet networks, facilitating communication between these systems.
Example Connections:
KNX devices are connected to the KNX port.
RS-485 DyNet devices are connected to the corresponding terminals (SHLD, GND, D+, D-, +12V, AUX/UL924).
Important Notes
This is a Class A product. In a domestic environment, this product may cause radio interference. The user may be required to take adequate measures to mitigate such interference.
Compliance and Trademarks
© 2022 Signify Holding. All rights reserved.
Specifications are subject to change without notice.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
For more information, visit www.dynalite.com.
Product Part Number: AZZ 423 0922 R17
