Delta Wearable Safety Beacons
Assembly and Operation Guide
Assembly Instructions
Parts Included
- 1x Beacon (Front & Rear)
- 1x Mount
- 1x Mount Band
Diagram showing the three components: A (Beacon), B (Mount), and C (Mount Band).
Operation Modes
| Action | Light Mode | Est. Run Time |
|---|---|---|
| Press once (1) | Pulsing | 10 Hours |
| Press again (2) | Constant Beam | 3.5 Hours |
| Press again (3) | Movement Detection* | 20 Hours |
*Three quick flashes indicate movement mode activation. The light will stop flashing if no movement is detected for 7 seconds.
USB Charging
Charge periodically using any USB port or when the light appears dimmer. Charge Time: approximately 50 minutes. The light shows a slow pulse while charging and a constant light when fully charged.
IMPORTANT NOTE: Failure to charge after extensive use may affect battery life.
Attach to Mount
- Slide the beacon into the mount, ensuring it is lined up securely.
- Attach the band by wrapping it around the bar and securing the other side to the bottom hook.
Diagram illustrating sliding the beacon into the mount and securing the band around a handlebar.
Attachment Option
Zip Ties (not included) can be used for permanent attachment of the mount and to secure it to larger size bars.
IMPORTANT NOTE: The maximum width for Zip Ties is 5mm (3/16").
Diagram showing zip ties being used to attach the mount to a bar.
Easy Attachment Anywhere
The beacons can be attached to various items:
- Backpacks
- Bicycle handlebars and frames
- Pet collars
Illustrations depicting the beacon attached to a backpack, bicycle handlebars, bicycle seat post, and a dog's collar.
Assembly Video
For assembly assistance, visit designbydelta.com/downloads.
QR code linking to the download page.
Safety Information
WARNING: Do not look directly into this light. It may cause temporary blindness.
CHOKING HAZARD: Not to be used by children under 5 years old.
