Danfoss VLT® Midi Drive FC 280 Terminal Torque Instructions

1 Installation Instructions

1.1 Description

These instructions provide information on the torque values for the terminal blocks used in the VLT® Midi Drive FC 280.

1.2 Part Numbers

Table 1: Accessory Bag Numbers (Cannot be Ordered as Spare Parts)

Table 2: Spare Part Numbers

1.3 Safety Precautions

Only Danfoss qualified personnel is allowed to install this equipment.

For important information about safety precautions for installation, refer to the drive's Operating Guide.

1.4 Tools Required

SZS 0.6x3.5 mm slot screwdriver.

1.5 Torque Instructions

NOTICE

DESTRUCTION OF TERMINALS OR LOOSE CABLES

• Applying too much torque can destroy the terminal blocks. Applying too low torque can result in loose cables.
• Only use a screwdriver as specified in 1.4 Tools Required.
• Apply the needed tightening torque as specified in Table 3.
• Do not apply more torque than the maximum torque as specified in Table 3.

Illustration 1: Tightening Torque for Terminals

Visual representation of various terminal plugs used in the VLT Midi Drive FC 280, numbered 1 through 11.

Table 3: Tightening Torque for Terminals