Bosch Semi-Integrated Dishwasher Installation Instructions

General Information

This document provides installation instructions for Bosch semi-integrated dishwashers. Ensure all steps are followed carefully for proper installation and operation.

Note: Some parts or services may be available through customer service.

Tools and Parts Required

The following tools and parts are typically required for installation:

• Screwdriver (e.g., Torx T20)
• Wrench (e.g., SW 10, SW 13)
• Measuring tape
• Level
• Drill (if necessary for mounting)
• Water supply hose
• Drain hose
• Electrical connection
• Mounting screws and brackets (as provided or specified)

Installation Steps

Follow the numbered steps below, referencing the diagrams for visual guidance.

Step 1: Preparation and Initial Mounting

Diagram 1: Shows initial measurements and placement. Ensure a clearance of approximately 12mm (Ø2) and 416-352mm. Attach mounting brackets as indicated.

Diagram 2a & 2b: Illustrates attaching the dishwasher to cabinetry. Use screws (e.g., 4x15mm, 4x30mm) and ensure the unit is properly braced. Avoid pinching any components.

Step 2: Water and Drain Connections

Diagram 3: Depicts connecting the water supply. Ensure the connection is secure and meets pressure requirements (0.05-1 MPa / 0.5-10 bar). The water temperature should not exceed 60°C.

Diagram 4: Shows the drain hose connection. The hose should not be longer than 4 meters. Ensure a proper connection to the waste pipe, with a minimum diameter of 22mm.

Step 3: Electrical Connection

Diagram 5: Illustrates the electrical connection. Ensure the power supply meets the appliance's requirements. Refer to the appliance's rating plate for specific voltage and wattage.

Step 4: Door Panel Attachment

Diagram 6: Details attaching the furniture door to the dishwasher. Ensure correct alignment and secure fixing using the provided hardware.

Step 5: Adjustments and Final Checks

Diagram 7: Shows how to adjust the leveling feet for a stable installation.

Diagram 8: Illustrates securing the dishwasher to the countertop or adjacent cabinets.

Diagram 9: Demonstrates attaching the kickplate or base panel.

Diagram 10: Shows final checks, including ensuring the door opens and closes correctly and that no components are pinched.

Diagram 11: Instructions for removing a disc, likely for a specific installation configuration.

Diagram 12: Shows how to adjust the height or position of the dishwasher.

Diagram 13: Instructions for checking for leaks after the first wash cycle.

Diagram 14: Details connecting the water inlet hose, specifying minimum and maximum lengths and diameters.

Diagram 15: Shows the final assembly and checks, including tightening screws and ensuring all parts are correctly fitted.

Diagram 20-34: Various close-ups and specific adjustment details, including water connection specifications (G 3/4" and G 1/2"), maximum torque (10 Nm), and hose lengths.

Important Notes:

• Ensure all connections are tight and leak-free.
• Verify that the dishwasher is level.
• Do not overtighten screws.
• Refer to specific model documentation for any variations.