ENHET Base Cabinet Assembly Instructions

Important Safety Information

⚠️ WARNING ⚠️

Serious or fatal crushing injuries can occur from furniture tip-over. To prevent this furniture from tipping over, it must be permanently fixed to the wall/floor.

Fixing devices for the wall/floor are not included since different wall materials require different types of fixing devices. Use fixing devices suitable for the walls/floors in your home. For advice on suitable fixing systems, contact your local specialized dealer.

Safety Recommendations:

• Place heaviest items in the lowest drawers.
• Prevent children from climbing or hanging on the drawers, doors or shelves.

Tools Required

You will need the following tools for assembly:

• Cross-head screwdriver ?
• Flat-head screwdriver ?
• Pencil ✏️
• Spirit level ?

Assembly Steps

Step 1: Assemble the cabinet frame.

Connect the side panels to the base panel. Then, attach the back panel. Finally, secure the top panel to the assembled frame.

Step 2: Attach hinge mounting plates to the cabinet body.

Attach two hinge mounting plates (part no. 10032274) to the inside of the cabinet body, near the top edge, using screws (part no. 151931).

Step 3: Attach hinges to the doors.

Attach hinges (part no. 10038464) to the doors using screws (part no. 130884, 130886).

Step 4: Install shelf supports.

Insert shelf supports (part no. 116630) into the pre-drilled holes on the inside of the cabinet side panels at your desired shelf height.

Step 5: Attach doors to the cabinet.

Clip the hinges on the doors onto the corresponding mounting plates attached to the cabinet body. You should hear a "CLICK!" sound.

Step 6: Adjust doors.

Adjust the doors for proper alignment. This typically involves adjusting the hinges for vertical ↕️, horizontal ↔️, and depth ↔️ positioning.

Step 7: Attach wall mounting brackets to the cabinet.

Secure two wall mounting brackets (part no. 10038457) to the top rear edge of the cabinet using screws (part no. 130884).

Step 8: Prepare for wall mounting.

Position the cabinet against the wall where it will be installed. Use a spirit level ? and pencil ✏️ to mark the wall through the holes in the wall mounting brackets. Ensure the marks are level.

Step 9: Secure wall brackets to wall.

Using appropriate wall fixings (not included) suitable for your wall type, securely attach the wall brackets to the wall at the marked positions.

Step 10: Mount cabinet to wall.

Align the cabinet's wall mounting brackets with the wall brackets and secure the cabinet in place.

Step 11: Insert shelves.

Place the shelves (part no. 10043847, 10046081) onto the installed shelf supports.

Step 12: Attach back panel supports.

Attach back panel supports (part no. 116630, 10043190) to the cabinet as indicated.

Step 13: Attach doors.

Attach the doors to the cabinet by clipping the hinges onto the mounting plates.

Step 14: Insert shelves.

Place the remaining shelves onto their respective supports.

Step 15: Attach wall mounting brackets.

Attach the wall mounting brackets (part no. 10043190) to the cabinet.

Note: The assembly steps are consolidated from various pages. Always refer to the visual cues in the original manual for precise placement and orientation.