Tow-Trust Towbars
Important: Please read General Notes overleaf before fitting
Issue 3
TJAG3VK-6242 JAGUAR F-PACE 2016> / RANGE ROVER VELAR 2017>
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | TJAG3 Crossmember | D | 1 | Flip Up Socket Plate (TTFP/RH) |
| B | 2 | Handed Side Arms | E | 8 | M14 x 90 Bolts & S/P Washers |
| C | 1 | 6242 Detachable Neck | F | 8 | M14 x 50 Bolts & S/P Washers |
| G | 2 | M12 x 22 Bolts & S/P Washers | |||
| H | 2 | M12 x 25 Bolts & S/P Washers | |||
| J | 16 | 14 X 27 Flat Washers | |||
| K | 4 | 12 x 25 Flat Washers |
Bumper Removal
- F-Pace Only: Remove four fixings securing the bumper lower edge to the undertray.
- Velar: Unclip the central bumper panel to reveal two fixings securing the bumper lower edge to the undertray and remove.
- Remove four fixings from each wheel arch liner, peel back and remove an additional three fixings either side.
- Remove the inner trim from each light cluster around boot opening; this will reveal one bumper fixing either side to remove.
- Velar: Remove the top scuff plate to reveal four fixings securing the bumper top edge.
- Starting at the bumper tips release the bumper from the vehicle body and then pull rearwards.
- Remove the black plastic bumper support to gain access to upper Towbar mounting points.
- Lower the exhaust silencers and support to prevent damage. Remove the heat shields.
- Remove the rear impact beam. (This is Not refitted with the Towbar assembly)
Towbar Installation
- Insert Items B into each chassis and fix in place using Items E and Items J.
- Fix Item A to the rear panel using Items F with Items J.
- Using Items H with Items K and Item G with Items K fix Item C and Item D to Item A.
- Fully tighten all fixings ensuring the Towbar is rigid, square and secure.
- Refit the exhaust heat shields and rehang the exhaust silencers.
- Refit the rear bumper support and rear bumper.
- Refit undertray (F-Pace) / panel (Velar).
Option 1: F-Pace: Cut the undertray as per the sketch below. Velar: Cut the central bumper cover as per the sketch below.
Option 2: F-Pace: Order the factory pre-cut undertray and fit. Velar: Order the factory pre-cut bumper panel and fit.
Diagram Descriptions
The main diagram illustrates the Tow-Trust TJAG3VK-6242 towbar assembly, detailing the crossmember (A), handed side arms (B), detachable neck (C), and flip-up socket plate (D). Various fixings (E-K) are shown in their respective positions for installation.
Additional visual aids include a sketch of the Velar OEM tow panel and a representation of the cut Velar panel, indicating the necessary modifications for installation.
Notes
1. Recommended Torque Setting for M12 Grade 10.9 - 130 Nm. (For other Torque Settings see notes overleaf.)
2. Nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.
