Caville Medicine Cabinet Assembly Instructions

Table of Contents

Refer to the following sections for detailed information:

• Safety Information
• Warranty
• Pre-assembly (Planning, Tools, Installation Guidelines)
• Package Contents
• Assembly Steps
• Consumer Responsibilities
• Maintenance
• Troubleshooting

Safety Information

[DANGER]

• Keep small parts away from children during installation. Failure to follow warnings and cautions could result in serious injury.
• DO NOT use harsh bathroom cleaners or grout cleaners on any natural stone.

[WARNING]

• Read these instructions carefully and keep in a safe place.
• Adult installation required.
• Do not overtighten connectors (screws, bolts, etc.). Overtightening can lead to product damage.
• Small parts may present a choking hazard prior to installation.
• Do not stand, step, or climb on the unit.

[CAUTION]

• Use preventative cleaning measures to keep your stone pristine.
• Use sealers according to the product-specific directions.
• Blot spills quickly, and wash with mild soap and warm water.
• Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during shipment. If parts are missing, contact THE HOME DEPOT to obtain any missing parts.
• Using abrasive cleansers will damage the surface.

NOTE: Please read and understand this entire manual before attempting to assemble, operate, or install the product.

• Handle the glass with caution! Improperly handling the glass can cause it to break.
• You will need at least two people to install this unit properly.
• The distributor is not responsible for any damage to the unit or personal property caused by improper installation.
• Carefully remove product from packaging and keep packaging until installation is complete.
• Inspect all parts for damage; if there is damage to the unit prior to installation, please contact customer service at the number provided in this guide.
• Install the product on a leveled surface.

Storage Instructions

• The product should be stored safely in a box of adequate size, with a piece of Styrofoam covering the entirety of the product placed on top and underneath.
• Store the unit in a dry and cool place, as humidity may damage the integrity of the electronics and other moisture-sensitive components.

Warranty

Limited Lifetime Warranty

• This warranty extends only to the original owner for personal household use. Commercial uses may have additional limitations.
• Home Decorators Collection warrants satisfaction with each mirror. If a mirror has a visual defect, return it to the retailer with original packaging before installation for replacement.
• Home Decorators Collection warrants mirrors to be free from defects in workmanship and materials under normal use for one (1) year.
• Home Decorators Collection will, at its election, repair, replace, or adjust any defects found during optional inspection within the warranty period.
• Home Decorators Collection is not responsible for installation or removal costs.
• Modification of any mirror's components may void the warranty.
• This warranty does not cover claims arising from abuse, misuse, negligence, accident, improper installation, or operation by the purchaser.
• This warranty is void if the product is altered or repaired by parties other than Home Decorators Collection.
• This warranty does not extend to components installed by dealers, installers, or third parties.
• Implied warranties, including merchantability or fitness for a particular purpose, are limited in duration to this warranty's period.
• Home Decorators Collection disclaims liability for special, incidental, or consequential damages.

What is Covered

• Home Decorators Collection products are manufactured with superior quality standards and workmanship, backed by a limited lifetime warranty.
• Products are warranted to the original consumer purchaser to be free of defects in materials or workmanship.
• Any defective product or part will be replaced FREE OF CHARGE. Return the product/part to any The Home Depot retail location or call 1-800-998-7021 for replacement.
• Proof of purchase (original sales receipt) from the original consumer purchaser is required for all warranty claims.

What is Not Covered

• This warranty excludes incidental/consequential damages and failures due to misuse, abuse, or normal wear and tear.
• This warranty excludes industrial, commercial, and business usage. Purchasers for such uses receive a one-year limited warranty from the date of purchase, with other terms applying except duration.
• Some states/provinces do not allow exclusion/limitation of incidental/consequential damages, so these limitations may not apply.
• This warranty grants specific legal rights, and you may have other rights varying by state and province. Please see a store or contact 1-800-998-7021 for details.

Pre-assembly

Planning Assembly

Check the cabinet for damage before installation. If any part is missing or damaged, contact the Customer Service Team at 1-800-986-3460. Ensure the cabinet location is accessible to water supply and drain lines. It is suggested to rough-in water lines and drain before installing the cabinet.

NOTE: A drain pipe and trap are not included with this cabinet.

Tools Required

• Safety goggles
• Philips head screwdriver
• Spirit level
• Tube of silicone sealant
• Clean cloth

Installation Guidelines

When installing this product, screws should reach the wood studs behind the plasterboard wall. Installation on a plasterboard wall is not recommended if screws and anchors are not secured in the wood studs.

[Diagram: Illustrates wall studs behind plasterboard, indicating the need to secure screws into studs.]

Package Contents

[Diagram: Shows the cabinet with parts A, B, and C labeled.]

Assembly

Step 1: Reversibility

This cabinet is up and down reversible.

[Diagram: Shows the cabinet in its standard orientation.]

Step 2: Reversibility

This instruction is drawn up for a door opening from left to right (see illustration A).

For an installation with a door opening from right to left (see illustration B), gently remove the shelves from the cabinet and reinstall them upside down.

[Diagram A: Shows the cabinet with the door opening to the right, with a close-up of shelf attachment points.]

[Diagram B: Shows the cabinet with the door opening to the left, with a close-up of shelf attachment points.]

Step 3: Installing Support Bars

Measure the height (H1) where the cabinet will be located. It is recommended to leave at least 9 inches [229 mm] clearance between the wall and the cabinet to ensure the full opening of the door.

Add 24-15/16 inches [634 mm] to height (H1). This calculated measure is the distance from the bottom of the support bar to the floor, as illustrated. Mark the bottom position of the support bar on the wall.

[Diagram: Shows height measurement H1 and the calculation H = H1 + 24-15/16" [634]. Also shows a support bar labeled and a measurement of 9" [229] clearance.]

Step 4: Installing Support Bars

Using a stud finder or equivalent tool, locate at least one wall stud and mark its positions on the wall for each support bar (A). While holding the support bar (A) in position against the wall, check that it is level, then mark 4 positions for 4 holes as indicated. One of the holes must be right over the wall stud.

[Diagram: Shows a support bar (A) being held against a wall, with marks for drilling. A close-up shows a 1" [25mm] measurement for hole placement on the support bar.]

Step 5: Installing Support Bars

Keep the support bars in position, then drill pilot holes on the wall through the support bar (A) at the marked positions using a ø1/8" (2.5mm) drill bit.

[Diagram: Shows drilling pilot holes through support bar (A) with a ø1/8" (2.5mm) drill bit.]

Step 6: Installing Support Bars

Except for the holes that are over the stud, drill the existing holes on the wall using a ø5/16" (8mm) drill bit and insert the wall anchors (B) into the holes using a rubber mallet until the wall anchors are flush with the wall.

[Diagram: Shows drilling larger holes for anchors and inserting wall anchors (B) with a rubber mallet.]

Step 7: Installing Support Bars

Replace and secure the support bar (A) with screws (C).

[Diagram: Shows securing the support bar (A) with screws (C).]

Step 8: Hang on the Cabinet

Gently hang the cabinet on the support bar (A).

[Diagram: Shows the cabinet being hung onto the installed support bar (A).]

Step 9: Securing the Cabinet

Open the door, measure and mark two holes. One of the holes must be right over the wall studs, respectively from the back of the cabinet. Make sure the two holes avoid the existing screws behind the cabinet at the indicated locations as shown below.

[Diagram: Shows measuring and marking two holes on the back of the cabinet, indicating a distance of 1-3/8" [35mm] from the top.]

Step 10: Securing the Cabinet

Drill pilot holes on the wall through the back of the cabinet as well as the support bar at the marked locations using a ø1/8" (2.5mm) drill bit.

[Diagram: Shows drilling pilot holes through the cabinet back and support bar.]

Step 11: Securing the Cabinet

Replace and secure the cabinet with screws (C) through the pilot holes.

[Diagram: Shows securing the cabinet to the wall with screws (C).]

Step 12: How to Remove / Install Shelves

REMOVE:

1. [Diagram: Shows detaching a shelf.]
2. [Diagram: Shows detaching another shelf.]

INSTALL:

1. [Diagram: Shows attaching a shelf.]
2. [Diagram: Shows attaching another shelf.]

Consumer Responsibilities

• Home Decorators Collection's mirror products will remain beautiful for many years if properly cared for.
• Home Decorators Collection does not recommend the use of harsh abrasive cleansers on any of its products. Harsh cleansers will damage the finish of your mirror.

Maintenance

• For daily maintenance, use a wet cloth and a soft liquid cleaner.
• Never use abrasive cleaners, strong bleach, scrapers, metallic brushes, or other objects that can graze or tarnish surfaces.

Troubleshooting