Advantium® Built-In Wall Oven CSB913 Installation Instructions

Safety Information

Before You Begin

Read these instructions completely and carefully.

IMPORTANT — Save these instructions for local inspector's use.

IMPORTANT — Observe all governing codes and ordinances.

Note to Installer — Be sure to leave these instructions with the Consumer.
Note to Consumer — Keep these instructions with your Owner's Manual for future reference.
Skill Level — Installation of this appliance requires basic mechanical and electrical skills.
Completion Time — 1 Hour.
Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the warranty. See Owner's Manual for warranty information.

IMPORTANT — Use this oven only for its intended purpose. Never use the oven for warming or heating a room. Prolonged use of the oven without proper ventilation can be hazardous.

CAUTION: For personal safety, remove house fuse or oven circuit breaker before beginning installation to avoid severe or fatal shock injury.

CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of the oven and drawer, plus additional oven loads.

Design Information

Product Dimensions and Clearances

Note: Appearance will vary by model.

Overall Dimensions: Width: 29-3/4 inches; Height: 20-1/4 inches.

Cabinet Opening Dimensions (Standard): Width: 23-1/2 inches; Height: 17-1/2 inches.

Required Clearances Around Cutout (Front Surface): 1-7/8 inches from the top, 2-3/8 inches from the side edges, and 1-1/8 inches from the bottom.

Cabinet Requirements: Minimum cabinet depth of 36-3/4 inches. Construct a solid bottom using minimum 3/8" plywood supported on all four sides, capable of supporting the oven's weight and contents.

Tools and Parts Required (Not Supplied)

#2 Phillips screwdriver
Hand-held drill
High speed drill bit, 3/32" diameter
3/8" slot-head screwdriver
Level
Saw
3/8" min. plywood for floor (if required)
Wood screws or other hardware for installing runner or shelf to support oven (if required)
Safety glasses or goggles

Advance Planning

Ovens can be installed directly into a 30" wide oven cabinet with standard installation.
Cutout height dimensions differ for installations with an accessory storage drawer. Use the correct cutout.
Allow clearance to adjacent corners, walls, drawers, etc.
Cabinets adjacent to wall ovens must have an adhesion spec of at least 194°F temperature rating.
The oven must be securely installed in a cabinet firmly attached to the house structure. Weight on the oven door could cause tipping and injury. Never allow anyone to climb, sit, stand, or hang on the oven door.
If installing a drawer accessory, assemble the drawer to the oven before installation into the cabinet. Refer to the Accessory Storage Drawer Assembly Instructions.

Flush Mount Installation

This method allows the unit face to be inline with the cabinet face. It requires a high skill level in carpentry, and non-standard cabinetry may be needed. Flush installation may expose cabinet face frame edges and side cleats, which should be finished.

Installation Preparation

Electrical Requirements

This Advantium Built-In Oven requires a 120-volt, 60 Hz, 15-amp circuit and draws 1.8 kilowatts. Ensure connection to a supply circuit of the proper voltage and frequency.

Wire size must conform to the National Electrical Code or prevailing local code.
The power supply cord and plug should connect to a separate 15 or 20 ampere branch circuit single grounded receptacle.
The outlet box should be located within reach of the 48" power cord.

Electrical Location

Locate the electrical outlet box in the back wall of the opening, within 6 inches of either side and at least 9 inches above the cutout floor.

Grounding Instructions

WARNING: Improper use of the grounding plug can result in a risk of electric shock.

This appliance must be grounded. Grounding reduces the risk of electric shock by providing an escape wire for electric current in case of a short circuit. The appliance is equipped with a power cord having a grounding wire and plug. Plug into a properly installed and grounded outlet.

If you have a 2-prong wall outlet, it is your responsibility to have it replaced with a properly grounded 3-prong outlet. Do not cut or remove the third (ground) prong from the power cord. Do not use an extension cord. If the power cord is too short, have a qualified electrician install an outlet nearby.

For best operation, plug the appliance into its own electrical outlet to prevent flickering lights, blown fuses, or tripped circuit breakers.

Standard Installation Preparation

The Advantium Built-In Oven can be installed in combination with other Built-In appliances. Always follow each product's Installation Instructions.

Single Advantium Built-In Oven Installation

Order a 30" wide single oven cabinet or cut the opening in a wall to the dimensions shown.

Cabinet Opening Dimensions: Width: 23-1/2 inches; Height: 17-1/2 inches. Minimum cabinet depth: 36-3/4 inches.

Support Structure: Construct a solid bottom using minimum 3/8" plywood supported on all four sides, capable of supporting the oven's weight and contents.

Other installation configurations are available, including:

Installation over a Warming Drawer
Installation over a Wall Oven
Installation over a Wall Oven and Warming Drawer
Installation over another Advantium Built-In Oven
Installation beside another Advantium Built-In Oven
Installation under a Microwave Oven and over a Warming Drawer
Installation under a 30" or 36" Cooktop or Countertop

Each configuration has specific dimensional requirements detailed in the original document.

Flush Mount Installation Preparation

This method requires precise carpentry for a flush fit with the cabinet face. Specific cleat dimensions and reveals are provided in the original document.

Preparation with an Accessory Storage Drawer

When installing with an accessory storage drawer, note the modified cutout height and follow specific instructions for drawer assembly and installation.

Installation Instructions

Step 1: Remove Packaging and Parts

Remove all packing material and tape.
Locate the parts package containing mounting screws.
Remove the oven from the carton. Do not lift by the handle or conduit; two people are required.
Open the door and remove any internal packaging.

Parts include: 5 Color-Matched Screws (4 required, 1 extra), 8 Brass Screws for Bottom Trim (3 required, 5 extra), Flat-Head Screws, Bottom Trim, Owner's Manual, Installation Instructions, Cooking Guide, Glass Tray, Turntable Ring, Metal Trays (2), Rack.

IMPORTANT: If installing with an accessory storage drawer, read the storage drawer assembly instructions first.

Step 2: Slide the Oven into the Cutout

CAUTION: Two people are required. Grasp the bottom at the front and rear. DO NOT USE THE HANDLE TO LIFT THE OVEN. DAMAGE WILL OCCUR.

Lift and hold the oven at the front of the opening, at an angle, and plug in the power cord.
Carefully slide the oven into the cabinet part way, leaving it a few inches forward of the cabinet frame.
Ensure the power cord is not trapped under or along the sides of the oven.

Step 3: Install Bottom Trim

Note: Bottom trim is not required if installing with an accessory storage drawer. Proceed to Step 5.

Align the trim tabs on the bottom trim to the slots in the bottom of the oven.
Secure the bottom trim to the bottom of the oven using 3 screws.

Step 4: Install Mounting Screws

Slide the oven fully into the opening so side flanges and control panel are against the cabinet frame. Ensure the oven is centered.
Open the door, place a turntable tray inside, and ensure it is level.
Drill pilot holes through the side flanges.
Drive the color-matched screws into the side flanges. Hand tightening is recommended.

If installing with an accessory storage drawer:

Open the drawer.
Drill pilot holes through the side flanges.
Drive color-matched screws into the side flanges. Hand tightening is recommended.

Step 5: Finalize Installation

Turn power on at the source. The interior light should illuminate when the door is opened.
Refer to the Owner's Manual for operating instructions.

Notes

Note: While performing installations described in this book, safety glasses or goggles should be worn.

Note: Product improvement is a continuing endeavor at GE Appliances. Therefore, materials, appearance, and specifications are subject to change without notice.

	Café 27-Inch Five-in-One Oven with 120V Advantium Technology \| CSB912P2VS1 Explore the versatile Café 27-inch Five-in-One Oven with 120V Advantium Technology (model CSB912P2VS1). Discover its features, benefits, specifications, and installation details for a seamless kitchen upgrade.
	Café Professional Series 30" Built-In Convection French-Door Single Wall Oven - CTS90FP4NW2, CTS90FP3ND1, CTS90FP2NS1 Explore the features and specifications of the Café Professional Series 30" Built-In Convection French-Door Single Wall Oven. This oven offers professional design, advanced cooking modes like True European Convection and Hot-Air Frying, a customizable aesthetic, and smart connectivity via the Café Appliances Kitchen app.
	Cafe Drawer Microwave Installation Instructions Comprehensive installation guide for the Cafe Drawer Microwave, covering safety precautions, unpacking, clearances, electrical requirements, standard installation, and flush mount options. Includes model numbers CWL112P2RS1, CWL112P4RW5, CWL112P3RD5.
	Café Advantium Oven Owner's Manual Comprehensive owner's manual for the Café Advantium Oven (Models CSB912, CSB913), detailing features, operation, safety, and care instructions for Speedcooking, convection, and microwave functions.
	CAFÉ CMB903P2NS1 30" Built-In Electric Steam Oven Owner's Manual Owner's Manual for the CAFÉ CMB903P2NS1 30" Built-In Electric Steam Oven. Includes safety instructions, operating procedures, cleaning guides, troubleshooting tips, warranty information, and consumer support details.
	Cafe Appliances Rebate: Save Up to $3000 on Select Suite Combinations Explore the Cafe Appliances 'Express Yourself' promotion offering up to a $3000 rebate on select kitchen suite combinations purchased between July 1 and December 31, 2025. Discover eligible models and rebate details.
	Café CTS92DM (30" Twin Flex) Convection Built-In Electric Wall Oven Owner's Manual This owner's manual provides comprehensive instructions and safety information for the Café CTS92DM (30" Twin Flex) Convection Built-In Electric Wall Oven, covering operation, cleaning, troubleshooting, and warranty details.
	Café Appliances Rebate Offer: Express Yourself with Select Suite Combinations Get up to a $3000 rebate on select Café appliance suite combinations purchased between July 1 and December 31, 2025. Explore bonus options for Wall Ovens, Cooktops, and Commercial-Style Ranges. Learn how to submit your rebate online and view eligible models.