Infinix NOTE 40 Pro

Exploded Diagram Specification

The following table details the components of the Infinix NOTE 40 Pro:

Know Your Phone

This section provides an overview of the Infinix NOTE 40 Pro's external features.

Front View:

• 1. Front camera
• 2. Volume + button
• 3. Volume - button
• 4. Power button

Back View:

• 5. NFC & Wireless charging indicator

SIM Card Installation

To install a SIM card:

1. Power off your phone.
2. Refer to the diagram for SIM card installation. The phone supports dual SIM cards (SIM 1 and SIM 2).

Charging the Phone

You can charge your phone using a charger or by connecting it to a computer via a USB cable. Use only Infinix chargers and cables to avoid damaging the device and invalidating your warranty.

The charging port is located at the bottom of the phone. A close-up view shows the USB-C port and audio jack.

FCC Caution

Labelling requirements:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• (1) This device may not cause harmful interference.
• (2) This device must accept any interference received, including interference that may cause undesired operation.

Information to user:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and may radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device causes harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards developed by independent scientific organizations. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement: The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: X6850 (FCC ID: 2AIZN-X6850) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.24 W/kg and when properly worn on the body is 0.78W/kg.

Body-worn Operation:

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user's body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved.

Operating System: Android™.

Android is a trademark of Google LLC.