Regulatory Compliance

FCC Compliance Information Statement

Product Details

Product Name: Omada 4G+ Cat6 AX3000 Gigabit VPN Gateway with 4-Port PoE+

Model Number: ER706WP-4G

Component Name: I.T.E. Power

Model: T535131-2-DT

Responsible Party

TP-Link Systems Inc.

Address: 10 Mauchly, Irvine, CA 92618

Website: https://www.tp-link.com/us/

Tel: +1 626 333 0234

Fax: +1 909 527 6804

E-mail: sales.usa@tp-link.com

Compliance Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Conditions of Operation

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.

Modifications

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

"To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 21 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter."

Declaration of Conformity

TP-Link Systems Inc. has determined that the equipment shown has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change made in the equipment and the equipment is properly maintained and operated.

Issue Date: 2025.08.05

I.T.E. Power Supply Compliance

Product Name: I.T.E. Power Supply

Model Number: T535131-2-DT

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

TP-Link Systems Inc. has determined that the equipment shown has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change made in the equipment and the equipment is properly maintained and operated.

Issue Date: 2025.08.05

CE Mark Warning

This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

[CE logo]

Operating Frequency (maximum transmitted power)

• 2400 MHz - 2483.5 MHz (20dBm)
• 5150 MHz - 5250 MHz (23dBm)
• 5250 MHz - 5350 MHz (23dBm)
• 5470 MHz - 5725 MHz (30dBm)
• WCDMA Band 1/3/5/8 (24dbm+/-1dbm)
• LTE Band 1/3/5/7/8/20/28/32/38/40 (24dbm+/-1dbm)

EU Declaration of Conformity

TP-Link hereby declares that the Gateway is in compliance with the essential requirements and other relevant provisions of directives 2014/53/EU, 2011/65/EU and (EU)2015/863.

The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce

RF Exposure Information (EU)

This device meets the EU requirements (2014/53/EU Article 3.1a) on the limitation of exposure of the general public to electromagnetic fields by way of health protection.

The device complies with RF specifications when the device is used at 21 cm from your body.

Frequency band: 5150 - 5250 MHz:

Indoor use: Inside buildings only. Installations and use inside road vehicles and train carriages are not permitted. Limited outdoor use: If used outdoors, equipment shall not be attached to a fixed installation or to the external body of road vehicles, a fixed infrastructure or a fixed outdoor antenna. Use by unmanned aircraft systems (UAS) is limited to within the 5170 - 5250 MHz band.

Frequency band: 5250 - 5350 MHz:

Indoor use: Inside buildings only. Installations and use in road vehicles, trains and aircraft are not permitted. Outdoor use is not permitted.

Frequency band: 5470 - 5725 MHz:

Installations and use in road vehicles, trains and aircraft and use for unmanned aircraft systems (UAS) are not permitted.

National Restrictions

This device may only be used indoors in Great Britain.

Specific national restrictions may apply in other regions as indicated by country codes:

• AT
• BE
• BG
• CH
• CY
• CZ
• DE
• DK
• EE
• EL
• ES
• FI
• FR
• HR
• HU
• IE
• IS
• IT
• LI
• LT
• LU
• LV
• MT
• NL
• NO
• PL
• PT
• RO
• SE
• SI
• SK
• UK(NI)

[UKCA logo]

UK Declaration of Conformity

TP-Link hereby declares that the Gateway is in compliance with the essential requirements and other relevant provisions of the Radio Equipment Regulations 2017.

The original UK Declaration of Conformity may be found at https://www.tp-link.com/support/ukca

NCC Notice

取得審驗證明之低功率射頻器材,非經核准,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

低功率射頻器材之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。

前述合法通信,指依電信管理法規定作業之無線電通信。

低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

應避免影響附近雷達系統之操作。

高增益指向性天線只得應用於固定式點對點系統。

減少電磁波影響,請妥適使用。

電波功率密度 MPE 標準值:0.45 mW/cm²,送測產品實測值:0.10 mW/cm²,建議使用時設備天線至少距:人體20公分。

BSMI Notice

Safety Consultation and Precautions

• Please use the original power adapter or only use the power type specified for this product.
• Please unplug the power cord before cleaning the product. Do not use liquid or aerosol cleaners or a damp cloth for cleaning.
• Beware of moisture; do not spill water or other liquids onto the product.
• Slots and openings are for ventilation to ensure reliable operation and prevent overheating; do not block or cover the openings.
• Do not place the product near heat sources. Do not place it in enclosed spaces without normal ventilation.
• Do not disassemble or repair the product yourself. If the product malfunctions, please contact the manufacturer or dealer.
• Warning: To avoid electromagnetic interference, this product should not be installed or used in residential environments.

Korea Warning Statements

당해 무선설비는 운용중 전파혼신 가능성이 있음. (This wireless equipment may cause radio interference during operation.)

Ukrainian Compliance

Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що передбачені чинними законодавчими актами України. [EAC logo]

Restricted Substances Information

Equipment Name: Omada 4G+ Cat6 AX3000 Gigabit VPN Gateway with 4-Port PoE+

Type Designation (Type): ER706WP-4G

Note 1: “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the percentage content of the restricted substance exceeds the reference percentage value of presence condition.

Note 2: “○” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence.

Note 3: The “-” indicates that the restricted substance corresponds to the exemption.

Safety Information

• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device. If you need service, please contact TP-Link Systems Inc.
• Do not use damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended by TP-Link.
• Do not use the device where wireless devices are not allowed.
• Adapter shall be installed near the equipment and shall be easily accessible.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• Plug the product into the wall outlets with earthing connection through the power supply cord.
• Place the device with its bottom surface downward.
• Use only power supplies which are provided by TP-Link and in the original packing of this product. If you have any questions, please contact TP-Link Systems Inc.
• Operating Temperature: 0°C ~ 40°C (32°F ~ 104°F)
• This product uses radios and other components that emit electromagnetic fields. Electromagnetic fields and magnets may interfere with pacemakers and other implanted medical devices. Always keep the product and its power adapter more than 15 cm (6 inches) away from any pacemakers or other implanted medical devices. If you suspect your product is interfering with your pacemaker or any other implanted medical device, turn off your product and consult your physician for information specific to your medical device.

Please read and follow the above safety information when operating the device. TP-Link cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.

Explanation of the Symbols on the Product Label

Note: The product label can be found at the bottom of the product and its I.T.E. power supply. Symbols may vary from products.