Tools Required: (Not included)
- A. Phillips head screwdriver
- B. Flat head screwdriver
- C. 4mm open wrench
- D. 19mm open wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before removing or installing the batteries. Failure to follow these steps in the correct order may cause irreparable damage.
Step 1
Remove the 4 Phillips screws at the back of the battery cover of your unit.
[Image description: Image showing the back of the unit with the battery cover in place.]
Step 2
Remove two 4mm hex screws on the right side of the battery tray.
[Image description: Image showing the right side of the battery tray with two 4mm hex screws visible.]
Step 3
Remove two 4mm hex screws on the left side of the battery cover and 1 Phillips screw located in the middle left side of the battery cover. Remove the cover away from the unit, carefully disconnecting the wires connected to the power switch and charger port.
[Image description: Image showing the left side of the battery cover with two 4mm hex screws and one Phillips screw, and disconnected wires.]
Step 4
Disconnect the black wire from the charger port that connects to the power switch. Using a flathead screwdriver, remove the silicone at the back of the charger port to access the secure nut.
[Image description: Image showing a hand disconnecting the black wire from the charger port using a flathead screwdriver to access a secure nut.]
Step 5
Using a 19mm open wrench, loosen the nut in a counter-clockwise motion.
[Image description: Image showing a hand using a 19mm open wrench to loosen a nut in a counter-clockwise motion.]
Step 6
Using a small pointy object, depress the locking pins on the prongs and push them out of the connector. Remove the old charger port from the cover.
[Image description: Image showing a hand using a small pointy object to depress locking pins on the charger port connector.]
Step 7
Reverse the procedures to install.
ATTENTION: Charge battery 12 hours before using.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
