Energizer QE20010PQ Power Bank

Product Overview

The Energizer QE20010PQ is a high-capacity power bank designed to charge your devices on the go. It features multiple charging options, including USB-A, USB-C PD, and wireless charging.

Specifications

Package Contents

How to Use

Recharge Mode

Blinking light indicates recharging. Solid light indicates fully charged.

[Illustration showing power bank being plugged in for charging]

Low-current Charging Mode

Press and hold the power button to activate low-current charging mode. The digits will blink when entering this mode. This mode provides continuous output without entering standby. To exit manually, press and hold the button again. The device will automatically exit after two hours of no load. This mode is recommended for charging low-current devices like earbuds and watches.

Fast Charge (via cable)

Connect only one device to the power bank to activate fast charge. Do not press the power button.

Wireless Charging

Press the power button once to activate wireless charging. Fast charge via cable will switch to normal charging mode. After 2 minutes of idle, wireless charging will shut off, and wired charging will resume fast charging.

FOD Protection: Green Light Flashes. Green light indicates wireless charging is activated.

Safety Instructions

• Avoid water, heat, fire, battery penetration, and severe drops at all times.
• Do not insert objects other than USB connectors into the USB ports.
• The power bank automatically shuts off when fully charged to save power.
• The battery may feel slightly warm during charge and recharge.
• Clean the exterior with a lightly wetted cloth or napkin; do not use water or other cleaning products.
• Battery performance may decline after 2 years.
• Intentional and physical damage to the battery is not covered by warranty.
• Battery storage temperature: -10°C to +60°C. Operating temperature: 0°C to 45°C.
• Fully charge the battery before first use to maximize battery life.
• Tip: Fully discharge and recharge the power bank a few times to improve battery level accuracy.

FCC Compliance

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF exposure compliance statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

NOTE: This device complies with Part 18 of the FCC Rules. Information to user. The device has potential interference, but the interference is very small and complies with FCC rule requirements.

PowerSafe Management

Guarantees against short circuit and over-charging for your power bank and devices.