Ryobi ONE+ 18V SwifTclean Wet/Dry Stick Vacuum

Important Safety Instructions

Always follow basic precautions when using electrical appliances. Read and understand all instructions before operating this appliance. Key safety points include:

• Wear appropriate clothing and keep hair, loose clothing, and jewelry away from moving parts.
• Maintain proper footing and balance; do not overreach or use on unstable surfaces.
• Use safety equipment, such as a dust mask, when necessary.
• Keep children away from the product and do not allow them to play with it.
• Use the product only for its intended purpose as described in this manual.
• Never vacuum burning or smoking materials, flammable or combustible liquids, or sharp objects.
• Do not use without the dust bowl or filter in place.
• Remove the battery pack before assembling, adjusting, cleaning, or when the product is not in use to prevent accidental starting.
• Do not use damaged or modified battery packs, as they can cause fires or explosions.
• Do not expose battery packs or the appliance to fire or excessive temperatures.
• Ensure the switch is in the off position before connecting to a power source or battery pack.
• Avoid contact with battery liquid; flush with water if contact occurs.
• Do not charge the battery in damp or wet locations or in temperatures outside the specified range.
• Recharge only with the specified charger.
• Use appliances only with specifically designated battery packs.
• Do not put hands or objects inside the floor nozzle attachment.
• This product is intended for use on hard surfaces only; do not use on carpet.

Symbols

Familiarize yourself with the following symbols used in this manual:

• DANGER: Indicates a hazardous situation that, if not avoided, will result in death or serious injury.
• WARNING: Indicates a hazardous situation that, if not avoided, could result in death or serious injury.
• CAUTION: Indicates a hazardous situation that, if not avoided, may result in minor or moderate injury.
• NOTICE: Indicates important information not related to potential injury.

Assembly

This product requires assembly. Carefully unpack the tool and accessories. Ensure all items listed in the 'Includes' section are present.

• Installing/Removing the Vacuum Handle: Refer to Figure 1. Insert the handle into the slot on top of the vacuum until it clicks. To remove, use a blunt tool to press the detent at the handle base and pull the handle up.

Operation

• Installing/Removing Battery Pack: Refer to Figure 2. Insert the battery pack until latches snap into place. Depress latches to remove.
• Removing and Filling the Clean Tank: Refer to Figure 3. Remove the battery pack, then the clean tank. Fill with water to the water fill line and add RYOBI Hard Surface Cleaning formula to the formula fill line. Close the tank door and reinsert.
• Starting/Stopping the Vacuum: Refer to Figure 4. Press the ON/OFF button to start. Step on the roller head and recline the handle to dispense solution. To stop, press the ON/OFF button and return the handle to the upright position.
• Max Suction Button: Press the MAX button to increase suction; press again to return to normal.
• Solution Pump Button: Press to stop dispensing solution; press again to resume.
• Using the Wet/Dry Stick Vacuum: Refer to Figures 5-6. This product is for hard surfaces only. Roll the vacuum over the surface, insert battery, and start. Recline the handle to begin cleaning. Stop the unit and remove the battery when finished.
• Dry Vacuuming: Refer to Figure 7. Vacuum small debris. Performance may decrease with a full dirty tank. Check the filter when emptying.
• Wet Vacuuming: Refer to Figure 8. The vacuum has a water float that shuts off suction when the dirty tank is full. Turn off and empty the dirty tank when full.
• Emptying the Dirty Tank: Refer to Figures 9-11. Remove the dirty tank, empty it, and replace the filter unit housing and the tank.
• LED Light Functions: The LEDs indicate the appliance status (Power ON, Battery level, Self-clean mode, etc.). Refer to the table for details.

Maintenance

• General Maintenance: Avoid solvents on plastic parts. Use clean cloths for cleaning. Keep away from brake fluids, gasoline, etc.
• Cleaning the Filter: Refer to Figure 12. Remove the battery, then the dirty tank. Lift the filter tab, shake off dust, and wash with clean water. Allow to dry completely (24 hours). Replace the dry filter.
• Using the Self-Cleaning Feature: Refer to Figure 13. Place the vacuum in the self-cleaning stand and press the self-clean pedal with your foot.
• Removing the Roller: Refer to Figure 14. Remove the battery, squeeze housing buttons to remove the cover, pull the roller lever, and remove the roller. Rinse if necessary and allow to dry.

Troubleshooting

If the product is not working properly, has been dropped, damaged, left outdoors, or dropped into water, return it to the nearest service center.

Warranty Information

This product is covered by a 3-year limited warranty. Proof of purchase is required. For service, replacement parts, or customer support, visit www.ryobitools.com or call 1-800-525-2579.