Thule Kit 186157 Installation Guide for Subaru Outback

Kit Overview

Kit Number: 186157

Brand: Thule

Compatible Vehicles:

• SUBARU Outback (BR Facelift only), 5-dr Estate, 2013-2014
• SUBARU Outback (BS), 5-dr Estate, 2015-2019
• SUBARU Outback (BT), 5-dr Estate, 2020-
• SUBARU Outback (BS), 5-dr Estate, 2014-2020 (Australia only)
• SUBARU Outback (BT), 5-dr Estate, 2021- (Australia only)
• (*North America compatibility may vary)

Important Note: This kit is designed exclusively for vehicles equipped with built-in foldable crossbars.

Standard Compliance: ISO 11154-E

Included Components

The kit includes the following parts:

• Part 075 (x2)
• Part 126 (x2)
• Part 073 (x2)
• Part 076 (x2)
• Part 127 (x2)
• Part 074 (x2)
• Part 54201 (x4)
• Foot Pack (x2)

Visuals from page 1 show individual components laid out with their respective quantities.

Specifications and Safety

Maximum Load Capacity: 60 kg / 132 lbs. This is indicated by a diagram showing a weight scale.

Maximum Speed: 130 km/h (80 Mph). This is shown with a speedometer graphic.

Recommended Speed Limit: 80 km/h (50 Mph) for optimal safety and performance. A separate diagram illustrates this speed limit.

A diagram on page 1 shows a warning symbol ⚠️ indicating potential hazards or restrictions.

Installation Instructions

Follow these steps carefully to install the roof rack system:

Step 1: Preparation

Identify all components: [KIT] parts, [FOOT PACK], Evo, and Edge components. Page 2, Step 1 shows an overview of the kit and foot pack parts.

Step 2: Foot Pack Assembly - Part A

Attach part A to the Foot Pack. Page 2, Step 2 shows part A being fitted onto the base of the foot pack.

Step 3: Foot Pack Assembly - Part B

Insert parts B into the Foot Pack. Page 2, Step 3 shows multiple parts B being inserted upwards into slots on the foot pack.

Step 4: Foot Pack Assembly - Part C

Attach part C to the assembly. Page 2, Step 4 shows part C being placed over the assembled foot pack components.

Step 5: Securing Components

Secure the parts using screws (x2 per foot pack). Page 2, Step 5 shows screws being used to fasten components.

Step 6: Final Assembly and Torque

Complete the foot pack assembly. Ensure all parts are correctly fitted. The recommended torque for securing bolts is 4 Nm. Page 2, Step 6 shows the completed foot pack assembly and a torque wrench symbol indicating 4 Nm.

Vehicle Fitment

The kit is designed for specific mounting points on the vehicle roof:

• Front Left (FL)
• Front Right (FR)
• Rear Left (RL)
• Rear Right (RR)

Use specific fitting parts like "Edge L" and "Edge R" as indicated for the respective sides of the vehicle. Page 1 diagrams illustrate the placement of the foot packs on the vehicle's roof rails at the FL, FR, RL, and RR positions, showing the specific "Edge L" and "Edge R" adapters.

Measurements

Ensure correct positioning using the following measurements:

• 780 mm (43 3/4 inch)
• 615 mm (24 1/4 inch)

Diagrams on page 2 show these measurements relative to the vehicle's roof structure.