User Manual for ACON Airtracks

Introduction

Thank you for purchasing an ACON airtrack product. This manual provides instructions for the safe and proper use of your Acon airtracks. Please read these instructions carefully before use. For any unclear points, contact ACON customer support.

General Instructions

• Always store and transport the airtrack in its carrying bag.
• Do not use the airtrack if it is damaged or leaking air.
• Choose an appropriate, level area for setup. Ensure the ground is free of sharp objects (rocks, gravel, etc.) to prevent damage.
• For outdoor use, set up on level, soft ground, preferably on a protective tarp or fabric.
• To clean the airtrack surface, wipe with lukewarm soapy water. Avoid strong cleaning solutions.
• Ensure the airtrack is clean and dry before rolling it up for storage.
• Recommended temperature for airtrack use: -10°C to +30°C (14°F to 86°F).
• Recommended temperature for storage: at least +5°C (41°F). Avoid storing in direct sunlight.
• Acon airtracks can bear a weight of 200 kg/m² (440 lb/10.76 ft²).

Certifications: CE, EN71, REACH

Hand Pump User Instructions

Inflating the Airtrack

Remove the airtrack from its carrying case and roll it out fully to make the valves accessible. Depending on the model, there may be one or two valves; either can be used for inflation or deflation. Use only the pump included with the airtrack.

Steps:

1. Open the valve cover.
2. Ensure the valve button is in the up-position.
3. Place the head of the pump tube into the valve and twist to the right to connect it tightly.

Recommended Pressure: 5-6 PSI. The bounciness is influenced by the pressure. Adjust to user preference. Pump until the desired air pressure is indicated on the pump's meter. Remove the pump head by twisting to the left. Replace the valve cover securely to prevent air leaks.

Deflating the Airtrack

Push the valve button into the down-position to open the valve.

If Air Leaks Around the Valve

Follow these steps:

1. Remove the valve key from its packing case.
2. Open the valve cover and place the valve key into the valve.
3. Turn the valve key clockwise until there is no space between the valve and the airtrack. Caution: Do not turn the key counterclockwise, as this can loosen, cause leaks, or detach the valve.
4. Close the vent and check if the leak has stopped.

Contact Us

Europe

Email: customercare.eu@acon24.com

Website: acon24.com/pages/customer-service

General Website: acon24.com

USA

Email: customercare.us@acon24.com

Phone: +1-866-297-5234

Website: us.acon24.com

Manuals

Find more manuals at: acon-manuals.com