Waterpik Waterflosser Quick Start Guide
Models: WP-660/662/663/670/672/673/674/675/676
Register your product and receive over $50 in savings: waterpik.com/registration
Watch the How To Video: waterpik.com/HowTo660
1. Unit Prep
A. Fill Reservoir
Fill the reservoir with warm water and replace it firmly on the base.
[Diagram: Water reservoir being filled with water.]B. Insert Tip
Insert the water flosser tip until it clicks into place.
[Diagram: Water flosser tip being inserted into the handle.]C. Test Flow
Turn pressure to [High]. Point the tip into a sink. Turn the power ▶️ and water switches ON until water flows. Turn switches ⏹️.
[Diagram: Water flosser head pointed into a sink, showing pressure controls (Low/High) and ON/OFF switches.]2. Water Floss
A. Start Flossing
Start on [Low] pressure and increase to your liking. Turn power ▶️.
[Diagram: Water flosser unit with power and pressure controls.]B. Use Water
Turn water ▶️. Close lips enough to prevent splashing, while still allowing water to flow from your mouth into the sink.
[Diagram: Person with lips partially closed, water flowing from flosser into mouth and into sink. Shows ON/OFF switch.]C. Aim Correctly
Aim water at the gumline at a 90-degree angle. Follow the gumline and pause briefly between teeth.
[Diagram: Close-up of teeth and gums, showing flosser tip aimed at the gumline at a 90-degree angle.]⚠️ To Avoid Mess: Keep Tip in Mouth While Unit is On.
This device is only compatible with voltages of 120 VAC, 60Hz.
©2017 Water Pik, Inc.