Ryobi 18V ONE+ Flexible LED Clamp Light

Important Safety Instructions

WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury.

When using electric appliances, basic precautions should always be followed, including the following:

• Read all the instructions before using the appliance.
• To reduce the risk of injury, close supervision is necessary when an appliance is used near children. Do not permit children to use light. It is not a toy.
• The temperature of the LED will become hot after being on for only a short period of time. This hot temperature can cause burn injury if touched and can create sufficient heat to melt some fabrics.
• To reduce the risk of electrical shock, do not put light or charger in water or other liquid. Do not place or store appliance where it can fall or be pulled into a tub or sink.
• If wrapped or in contact with fabrics, the light lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the light lens to come in contact with anything.
• Do not use or permit use of light in bed or sleeping bags. This light lens can melt fabric and a burn injury could result.
• Use only the charger supplied by the manufacturer to recharge.
• Use this product only with batteries and chargers listed in tool/appliance/battery pack/charger correlation supplement 987000-432.
• Use only recommended battery pack. Any attempt to use another battery pack will cause damage to your light and could possibly explode, cause a fire, or personal injury.
• Remove battery pack from light before performing any routine maintenance or cleaning.
• Do not disassemble the light.
• Do not place or operate LED light, battery or charger near fire, heat, or flammable liquids/gases. They may explode. Also, do not dispose of a worn out battery pack by incinerating. Do not incinerate the battery, even if it is severely damaged or completely worn out. The battery may explode in fire.
• Keep light dry, clean, and free from oil and grease. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products, or any strong solvent to clean the light.
• Don't expose light to rain. Water entering a power tool will increase the risk of electric shock or malfunction.

Light Use and Care

• This product is for household use only.
• Always remove battery pack before storing the device.

Symbol Meanings

• [DANGER]: Indicates a hazardous situation, which, if not avoided, will result in death or serious injury.
• [WARNING]: Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
• [CAUTION]: Indicates a hazardous situation, that, if not avoided, may result in minor or moderate injury.
• [NOTICE]: Indicates information considered important, but not related to a potential injury (e.g. messages relating to property damage).

Product Symbols

• [!]: Safety Alert - Indicates a potential personal injury hazard.
• [?]: Read Operator's Manual - To reduce the risk of injury, user must read and understand operator's manual before using this product.
• [?]: Wet Conditions Alert - Do not expose battery or internal flashlight components to rain or water.
• [♻️]: Recycle Symbols - This product uses Lithium-ion (Li-Ion) batteries. Local, state or federal laws may prohibit disposal of batteries in ordinary trash. Consult your local waste authority for information regarding available recycling and/or disposal options.

Electrical Symbols

• V: Volts (Voltage)
• min: Minutes (Time)
• DC: Direct Current (Type or a characteristic of current)

Product Specifications

• Light Output: 400/200 Lumens (Flood) or 200/100 (Spot)
• Neck Length: 16 inches (40.64 cm)

Operation

Refer to Figures 1-3 for operation details.

Figure 1: Parts Identification

• A - Flexible neck
• B - LED lens
• C - Hi/low/off button
• D - Clamp
• E - Battery pack
• I - Pivoting collar

Figure 2: Clamp and Light Direction

• A - Squeeze the ends of the clamp to open the clamp mouth and install the light to a mounting surface that is 1-3/4 in. thick or less.
• B - Pull out for spot light.
• C - Push in for flood light.

Figure 3: Battery Pack

• F - Insert the battery pack into the battery port.
• G - Ensure latches snap into place and the battery pack is secured before operation.
• H - Depress latches and pull to release and remove the battery pack.

Important Warnings

• WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
• WARNING: Do not direct the light beam at persons or animals and do not stare into the light beam yourself (not even from a distance). Staring into the light beam may result in serious injury or vision loss.

Service and Warranty

To request service, purchase replacement parts, locate an Authorized Service Center and obtain Customer or Technical Support:

Visit www.ryobitools.com or call 1-800-525-2579

If any parts or accessories are damaged or missing, do not return this product to the store. Call 1-800-525-2579 for immediate service.

Please obtain your model and serial number from the product data plate. This product is covered under a 3-year limited Warranty. Proof of purchase is required.