YITAHOME

Exploded view showing all major panels (1-13) and hardware (A, B, J) for initial frame assembly.

Begin by identifying all panels and hardware. Prepare for the initial frame assembly.

Panel 9 is shown being slid into place within the partially assembled structure, indicated by an orange arrow.

Slide Panel 9 into its designated position within the main structure.

Panels 5, 6, and 2 are attached to panel 9 using hardware A and B. The diagram illustrates the screw and panel alignment.

Attach Panels 5, 6, and 2 to Panel 9 using Screws A and B. Ensure proper alignment before fastening.

Panels 3 and 4 are attached to the main structure using hardware A and B, showing screw insertion points.

Connect Panels 3 and 4 to the main structure using Screws A and B. Align the panels and insert screws into the pre-drilled holes.

Panels 7 and 8 are attached to the structure using hardware A and B. Arrows indicate the direction of attachment.

Attach Panels 7 and 8 to the main structure using Screws A and B. Follow the indicated attachment points.

The main frame is assembled using hardware A and B, showing multiple connection points.

Continue assembling the main frame by connecting various panels using Screws A and B at the designated points.

Further assembly of the main structure is shown, connecting panels with hardware A and B.

Complete the structural assembly by connecting remaining panels with Screws A and B.

Components are installed using hardware C (screws), G (shelf pins), and H (LED controller). Close-ups show screws being driven into pre-drilled holes and shelf pins inserted into designated slots.

Install components using Screws C (3.5*14), Shelf Pins G, and the LED Controller H. Insert shelf pins into the side panels and secure other components with screws.

Drawer slides or similar fittings are attached using hardware C (screws) and J (cam lock screws). Close-ups detail the cam lock mechanism for securing panels.

Attach drawer slides or similar fittings using Screws C (3.5*14) and Cam Lock Screws J. Ensure the cam lock mechanism is properly engaged for secure connections.

Panels are attached using hardware D (screws) and E (wooden dowels). Close-ups illustrate dowel insertion and screw tightening.

Connect panels using Screws D (3.5*25) and Wooden Dowels E. Insert dowels into their holes and then secure with screws.

Components are attached using hardware G (shelf pins) and C (screws). Close-ups show the connection points for shelf support.

Attach components, likely for shelf support, using Shelf Pins G and Screws C (3.5*14). Ensure pins are firmly seated.

The LED controller (H) is installed and connected. A close-up shows the LED controller unit and its RF remote control.

Install the LED Controller H. Connect it to the power source and any LED strips as per the controller's instructions. The unit comes with an RF remote control.