Honeywell Home Smart Home Security - Access Sensor
Quick Start Guide
Installation and Setup
Your Honeywell Home app must be used to install and configure this sensor. You need to install the app first.
If your system is already installed, open your Honeywell Home app to install the sensor.
Please wait to pull the tab on the sensor until you are instructed by the app. ❌
Online Guides available at: resideo.com
[BC]
Regulatory Information
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
For additional FCC information, see: FCC Compliance Information
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. It should be installed and operated with a minimum distance of 20cm between the radiator and your body.
IC Regulations
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. It should be installed and operated with a minimum distance of 20cm between the radiator and your body.
Product Information
Manufactured by Resideo Technologies, Inc.
Address: 1985 Douglas Drive North, Golden Valley, MN 55422
Phone: 1-800-633-3991
The Honeywell Home trademark is used under license from Honeywell International Inc.
©2019 Resideo Technologies, Inc. All rights reserved.
Model Numbers: 33-00338EF-03, 33-00336EF-03
