SVAKOM VESPER User Manual
Explore Your Limits
Introduction
This manual provides instructions for the SVAKOM VESPER vibrator. Please read all safety instructions carefully before use. The product is 100% waterproof.
Note: Before using a new SVAKOM vibrator, please fully charge the vibrator and clean it before using it on your body.
1. Buttons Display
The SVAKOM VESPER features the following buttons:
- "S" Button: Used for power on/off, switching vibration modes, and entering climax mode.
- Heating Button: Used to activate the heating function.
Vibration Modes (10+1):
Mode | Description | Vibration Graph |
---|---|---|
M1 (Climax Mode) | Climax Mode | Vibration Graph: M1: 〰️〰️〰️〰️〰️ M2: 〰️〰️〰️〰️〰️ M3: 〰️〰️〰️〰️〰️ M4: 〰️〰️〰️〰️〰️ M5: 〰️〰️〰️〰️〰️ M6: 〰️〰️〰️〰️〰️ M7: 〰️〰️〰️〰️〰️ M8: 〰️〰️〰️〰️〰️ M9: 〰️〰️〰️〰️〰️ M10: 〰️〰️〰️〰️〰️ |
M4-M7 (Joyous Mode 1-2, Caressing Mode 1-2) | Joyous Mode 1, Joyous Mode 2, Caressing Mode 1, Caressing Mode 2 | Vibration Graph: M4: 〰️〰️〰️〰️〰️ M5: 〰️〰️〰️〰️〰️ M6: 〰️〰️〰️〰️〰️ M7: 〰️〰️〰️〰️〰️ |
M8-M10 (Passionate Mode 1-3) | Passionate Mode 1, Passionate Mode 2, Passionate Mode 3 | Vibration Graph: M8: 〰️〰️〰️〰️〰️ M9: 〰️〰️〰️〰️〰️ M10: 〰️〰️〰️〰️〰️ |
Note: The default vibration mode is M1.
To use vibration modes:
- Single-click the "S" button to enter climax mode.
- Single-click the "S" button again to exit climax mode.
- Single-click the "S" button to switch vibration modes.
2. On / Off
- Press and hold the "S" button for 3 seconds to turn the vibrator ON. The default vibration mode is M1 with intensity L3.
- Press and hold the "S" button for 3 seconds to turn the vibrator OFF.
3. Heating Function
- Press and hold the heating button for 2 seconds to turn ON the heating function.
- Press and hold the heating button for 2 seconds to turn OFF the heating function.
Note: The heating function can be used independently, provided there is sufficient battery power.
4. Status Display
Status | Indicator Light |
---|---|
Vibrator ON | Solid light |
Vibrator OFF | Light flashes three times and then turns off |
Low battery | Light flashes three times and then turns off |
While charging | Flashing light |
Fully-charged | Solid light |
Heating status | Flashing light |
Quality and Certifications
SVAKOM products meet high quality standards from Europe and America. They are manufactured using environmentally friendly materials, including medical-grade silicone and ABS plastics, which are harmless to the human body.
SVAKOM products have passed EU ROHS certification and meet EU CE Directive and WEEE Directive, signifying compliance with environmental and safety standards.
- EU CE Directive: Indicates compliance with European Union product standards.
- ROHS: Restricts the use of certain hazardous substances in electronic products.
- WEEE: Governs the disposal of waste electrical and electronic equipment.
Safety and Maintenance
General Safety:
- Clean the product thoroughly with antibacterial soap and warm water before and after each use.
- Do not use massage oil or hand cream as a lubricant.
- Do not use silicone-based lubricants, as they can damage the product's surface.
- Avoid using cleaning agents containing alcohol, gasoline, or acetone.
- Keep the product away from direct sunlight and high temperatures. Store in a clean, dry place.
Battery Maintenance:
- This product uses rechargeable batteries. A new battery reaches its full effectiveness after 2-3 charging/discharging cycles.
- The battery can be charged over 100 times. Disconnect the charger once fully charged to prevent overcharging, which can reduce battery life.
- Battery charge may decrease gradually during periods of inactivity.
- Extreme temperatures (hot or cold) can reduce battery capacity and lifespan.
Battery Warning:
- Improper use or attempts to open the battery may cause fire or chemical burns. If the battery is damaged, stop using the product immediately, as it may explode.
- Dispose of batteries according to local regulations. Recycle whenever possible. Do not attempt to remove or replace the battery yourself, as this may damage the product or cause injury.