Goldair – Goldair.nz
Goldair Australia
Goldair New Zealand – Goldair NZGoldair New Zealand – Goldair NZ
Goldair Australia – Goldair AUGoldair Australia – Goldair AU
Instruction Manual for Goldair models including: GSCV120 2000W Convector Heater, GSCV120, 2000W Convector Heater
Convector Heater- GSCV120 – Goldair.nz
File Info : application/pdf, 8 Pages, 389.52KB
DocumentDocumentOperating Instructions 2000W Convector Heater Model : GSCV120 General Care and Safety Guide YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they are supervised or have been given instruction concerning the use of the appliance by a person responsible for their safety. · Children should be supervised to ensure that they do not play with the appliance. · If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. WARNING: You must not cover this appliance. Covering this appliance presents fire risk and will activate the safety fuse; permanently disabling the unit. WARNING: Do not use this appliance in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided. WARNING: To reduce the risk of fire, keep textiles, curtains, or any flammable material a minimum distance of 1 metre from the air outlet. · Use only the voltage specified on the rating label of the appliance. · Keep all objects at least 1 metre from the front, sides and rear of the appliance. · This appliance is intended for household use only and not for commercial or industrial use. · Indoor use only. · Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock or injury. · Do not use the appliance if it has been dropped or damaged. · The common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills. General Care and Safety Guide · Never use the appliance to dry clothes. · Always unplug appliance when not in use. · When the appliance has been unpacked, check it for transport damage and ensure all parts have been delivered. If parts are missing or the appliance has been damaged, contact the Customer Services Team. · Do not use if there are visible signs of damage to the appliance. · Do not connect the appliance to mains supply until completely assembled and adjusted. · Ensure hands are dry before handling the plug or main unit. · Ensure appliance is on a flat, stable, heat-resistant surface. · Do not operate with cord set coiled up as a heat build up is likely, which could be sufficient to become a hazard. · Carry out regular checks of the supply cord to ensure no damage is evident · Do not operate this appliance with a damaged cord, plug or after the appliance malfunctions or has been dropped or damaged in any manner. Take to a qualified electrical person for examination, electrical service or repair. · Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and split. Always ensure that all cord has been removed from any cord storage area and is unrolled before use. · It is recommended that this appliance is plugged directly into the wall socket. Power boards are not rated to supply power to high wattage appliances. · A correctly specified, undamaged extension cord may be used with this appliance provided it is used in a safe manner. · Do not remove plug from power socket until the appliance has been switched off. · Do not remove plug from power socket by pulling cord; always grip plug. · Do not place cord under carpet or cover with rugs or furniture. Arrange the cord so it cannot be tripped over. · Don't place appliance on bedding or on thick & long carpet where the openings may get blocked. · Switch off and use handle provided when moving · Do not place appliance close to radiant heat source. · Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock, fire or damage to the appliance. · Do not sit on the appliance. · Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) rinsed in hot soapy water only. Always remove plug from the mains supply before cleaning. · Do not operate in areas where petrol, paint or other flammable liquids are used or stored. · Do not use this appliance in the immediate surrounds of a bath, a shower, or a swimming pool or other liquids. General Care and Safety Guide · The appliance must not be immersed in any liquids. · There are no user serviceable parts installed in the unit. · Do not place the unit in wardrobes or other enclosed spaces as this may cause fire hazards. · This unit is not supposed to be used in or around locations where foodstuffs, works of art or delicate articles of science, etc. are stored. · If your appliance does not work, or is not working properly, contact the place of purchase or the Customer Services Team. Assembly WARNING: Heater must not be used without the feet fitted. This appliance has been supplied with `1 way screws' for permanent installation of the feet. This is a safety requirement for the New Zealand and Australian market. Remove the packaging. Check to ensure tha t all pa rts of this hea ter, cord and plug a re not damaged. Confi rm all pa rts before disposing of ca rton. Do not lea ve packaging ma terials like bags and staples wi thin reach of children or animals. 1 x Convector Heater 2 x Feet 4 x Screws (taped to one of the feet) Scre w holes in base of heater Screws in position once fitted to heater ASSEMBLY Ea ch foot supplied wi th this heater (supplied separa tel y in the ca rton) requi res onl y 2 s crews to a ttach them s ecurely to the heater. Holes are pre-drilled in the base of the heater. The s crew pa ck to a tta ch the feet to your hea ter will be taped to either one of the feet for your heater, or taped to the plug head. TIP: Slightl y a ngle the s crews into the holes when you i nsert them. As you tighten them, they will s tra ighten and secure the feet. The foot comes with 4 pre-drilled holes. It does not matter which way round you mount them. The pi ctures above show the l ocation of pre-drilled holes on the heater base. Operating Your Heater Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions. WARNING: In order to avoid overheating or fire, do not cover the heater. WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance. WARNING: Do not use this heater with a programmer, separate timer, remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. WARNING: Never leave this heater unattended when in use. Ensure heater is on a flat, stable, heat-resistant surface. Once the heater is in a safe operating position and all switches are in the off position, insert the power plug into the mains outlet and switch on. CAUTION: Ensure the power cord is not tight because if pulled it may partially pull the plug from the socket. A partially inserted plug will overheat the plug and socket and could result in fire. Note: When the appliance is turned on for the first time, it may release a slight odour or smoke. This odour or smoke is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again. HEAT CONTROL SWITCHES "750W" - Low heat "1250W" - Medium heat "2000W" - High Heat (750W & 1250W switches together) THERMOSTATIC CONTROL 1. Rotate thermostat knob clockwise until you reach the maximum position. 2. When the room reaches a temperature that is comfortable for you, slowly turn the knob anti-clockwise until the heater just turns off (you will hear a click). 3. The heater will now cycle on and off to maintain the comfort level you have set. 4. Take note of this setting position for future use. Operating Your Heater SAFETY DEVICES This appliance has two protection devices: · Resettable Thermal Link - this will automatically disconnect the power to the appliance at a pre-set overheat temperature. After cooling down it will reset and power on again. If this occurs, investigate what is causing the appliance to overheat. · Thermal Fuse - this disconnects the appliance permanently in case of overheating. (It is non resettable). CAUTION: The heater generates heat during use. Precautions must be taken to prevent the risk of burns, scalds, fires or other damage to persons. CARE AND CLEANING · The heater requires regular cleaning to ensure trouble free operation: · Unplug the heater from the mains supply before cleaning. · Ensure that the heater has been allowed to cool down completely before cleaning. · The common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills. · Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and di rt. · Never use solutions such as petrol, thinners or polishing agents. · Ensure the heater is dry before plugging back into the mains supply. · Do not attempt to dismantle the appliance. · There are no user serviceable parts. For service or repair, contact an authorised electrical service technician PROOF OF PURCHASE To receive warranty retain receipt as proof of purchase. TECHNICAL SPECIFICATION Model No: GSCV120 Supply: 220-240VAC 50Hz Wattage: 1800-2000W SUPPORT AND TECHNICAL ADVICE Goldair New Zealand Monday Friday 8am-5pm Phone +64 (0)9 917 4000 Goldair Australia Monday Friday 8am-5pm Phone +61 (0)3 9365 5100 Phone 0800 232 633 Phone 1300 465 324 info@cdb.co.nz info@cdbgoldair.com.au Two Year Warranty Thank you for purchasing this Goldai r Sel ect product. Your p roduct is warranted against f aults and manufacture wh en used in normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three months. Goldair undert ake to repai r or repl ace this product at no charge if found to be d efect ive du e to a manufac turing faul t during the warranty period. This warranty excludes damage c aused by misuse, neglec t, shipping accident , incorrect install ation, o r work c arried out by anyone other than a qualified electrical service technician. PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY. The b enefi ts giv en to you by this warranty are in addition to oth er ri ghts and remedies av ailabl e to you under law in rel ation to the goods or services to which this warranty relates. In Australi a, our goods come with guarantees that c annot be excluded under the Austral ian Consumer Law. You are entitl ed to a replac ement or refund for a major failure and comp ensation for any oth er reasonably fo res eeable loss or damage. You are also entitl ed to hav e the goods repai red o r repl ac ed if the goods fail to b e of accept abl e quality and the failu re do es not amount to a major failure. In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993). Goldair New Zealand C D B G oldair P O Box 100-707 N .S .M .C A uckland P hone +64 (0)9 917 4000 P hone 0800 232 633 w w w .goldair.co.nz Goldair A ustralia C DB G oldair A ustralia P ty P O Box 574 S outh M orang V ictoria, 3752 P hone +61 (0)3 9365 5100 P hone 1300 G O LDAIR (1300 465 324) w w w .goldair.com.au Goldair Select Two Year Warranty (IMPORTANT: Please complete and retain this warranty card) Name Address Place Of Purchase Date Of Purchase Name Of Product Model Number Attach a copy of the purchase receipt to this warranty card Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product . New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.au