Bona SuperSport Zone Paint
Two-Component, Water-Based Paint
Paint for excellent adhesion and coverage
Bona SuperSport Zone Paint is a PUR-based paint for marking zones and larger areas on sports floors. Thanks to its excellent adhesion properties, it is compatible with a variety of surfaces, including existing wooden floors and elastic floor coverings. This paint is also an integral part of the Bona SuperSport System. Due to its pigmentation, full coverage is typically achieved with one coat for darker colors, or two coats for lighter colors. The paint is available on order in all RAL and NCS colors.
- Heavily pigmented for excellent coverage
- Ultra-quick drying
- Low in odour
Features an A+ rating for indoor air emissions.
Technical Data
| Base: | 2-component, water-based polyurethane paint |
|---|---|
| Mixing Ratio: | 1 part Bona SuperSport HD Hardener to 11 parts Zone Paint (≈8.2% by volume) |
| Pot Life: | Max. 3 hours at 20°C (shorter at higher temperatures) |
| Dilution: | Do not dilute. If necessary, use 4% Bona Retarder for a longer open time. |
| Drying Time: | Recoatable: approx. 2-4 hours¹ Full cure: 3 days¹ |
| ¹Under normal room climate conditions, 20°C/60% relative humidity. | |
| Application Equipment: | Bona SuperCoat Roller (11 mm pile) |
| Application Rate: | 12 to 15 m²/litre (70-90 g/m²) per coat |
| Giscode: | W2/DD+ |
| Safety: | Paint/Varnish: not subject to labeling Hardener: subject to labeling, see Safety Data Sheet. |
| Tool Cleaning: | Tools can be cleaned immediately after use with water; hardened residues can only be removed with acetone. |
| Shelf Life: | Minimum 2 years from date of manufacture in unopened original packaging. |
| Storage/Transport: | Do not store/transport below +5°C or above +30°C. Ideal between 5-20°C. |
| Container Disposal: | Germany: via DSD Austria: Bonus No. 3551 |
| Delivery Form: | 5 litres including hardener (4.6 litres paint and 0.4 litres hardener) |
Please also refer to the information in the Safety Data Sheets.
Surface Preparation
It is essential that the floor covering is completely free of contaminants that could negatively affect the adhesion of Bona SuperSport Zone Paint. The removal of polishes, maintenance treatments, or other contaminants is a crucial step for the successful application of Bona SuperSport Zone Paint.
Sports Floors on Wood
Unfinished Wood
- 1 x Bona SuperSport Primer
- 1 x Bona SuperSport ONE/Bona SuperSport HD
- Intermediate sanding, 150 grit
- 1-2 x Bona SuperSport Zone Paint
- 1 x Bona SuperSport Line Paint
- 1-2 x Bona SuperSport ONE/Bona SuperSport HD
Finished Parquet with UV Lacquer
- Cleaning and sanding
- 1-2 x Bona SuperSport Zone Paint
- 1 x Bona SuperSport Line Paint
- 1-2 x Bona SuperSport HD
Elastic Sports Floors
Elastomer/Rubber and PVC
- Cleaning and sanding
- 1-2 x Bona SuperSport Zone Paint
- 1 x Bona SuperSport Line Paint
- 2 x Bona SuperSport Pure HD
Linoleum Floors
- Cleaning and sanding
- 1 x Bona LinoPrime
- 1-2 x Bona SuperSport Zone Paint
- 1 x Bona SuperSport Line Paint
- 1-2 x Bona SuperSport Pure HD
Processing
General Recommendations
Due to the specific structure of cast PU floor coverings, there is a risk of migration of components into the floor covering, which can lead to discoloration. For this reason, Bona does not recommend using Bona SuperSport Zone Paint on cast PU floors.
Optimal processing conditions are between 18-22°C and 40-60% relative humidity. High temperatures and low humidity shorten drying time, while low temperatures and high humidity prolong drying time.
Application Steps
- Check the color code and batch number on the paint container. Use paint from the same batch number on the same floor. Alternatively, the entire amount of paint to be used can be carefully mixed together in a separate container to ensure color consistency.
- Mix the paint thoroughly and pour the required amount into a separate container, e.g., a Bona Mixing Bucket.
- Slowly add 8.2% Bona SuperSport HD Hardener (one full bottle per bucket) to the mixing bucket while stirring mechanically. Stir thoroughly mechanically for at least 1 minute.
- Allow the mixture to react for at least 5 minutes before application and use the mixture within the recommended pot life of a maximum of 3 hours.
- Apply the mixed paint with a Bona SuperCoat Roller (11 mm pile) at approx. 12-15 m²/l. Roll with a uniform, flowing motion, avoiding puddles.
- Normally, an additional coat of Bona SuperSport Zone Paint is not required, and you can proceed with 1 to 2 coats of the corresponding Bona SuperSport varnish. To ensure good adhesion, the next coat, whether paint or varnish, should be applied within a maximum of 48 hours. If this period is exceeded, intermediate sanding with a Bona Scrad Pad must be performed. After sanding, the surface must be thoroughly dusted before applying the next coat.
Important Notes
Note: Bona SuperSport Zone Paint should never be used as a final seal.
Tip: Intermediate sanding of a coat should ideally be avoided, as there is always a risk that the color tone may be disturbed, which would require another coat. If it is known that, for example, more than 48 hours are needed after the last coat of Bona SuperSport Zone Paint to complete the line marking, it is best to apply a coat of Bona SuperSport varnish to the Bona SuperSport Zone Paint within 48 hours and then proceed with the line marking. The varnish can then be intermediate sanded before further coats without the risk of disturbing the color of the Bona SuperSport Zone Paint.
Important Warnings
- Plasticizers contained in materials such as carpet underlays, furniture feet, castors, and adhesives can lead to softening and discoloration. Contact with hair dyes or rubber tires from cars, bicycles, and strollers can cause permanent, irreversible discoloration of the surface. Use protection or avoid contact completely.
- Due to the specific composition of PU floor coverings, there is a risk of migration of components from the floor covering, which can lead to discoloration. For this reason, Bona advises against the use of Bona SuperSport Zone Paint on PU floors.
