VEGER V0102 Portable Charger for Apple Watch

Welcome Guide

Thank you for purchasing the VEGER V0102 1200mAh Power Bank for Apple Watch. Please read this user manual carefully and keep it for future reference. If you need any assistance, please contact our support team with your product model number and Amazon order number.

Product Diagram

The product diagram illustrates the VEGER V0102 portable charger, highlighting its key components: USB-C input port, LED indicator lights, and the power on/off button.

How to Recharge VEGER V0102 Apple Watch Portable Charger?

Recharge the portable charger via the USB-C cable input as shown.

How to Charge Your Apple Watch

Connect your Apple Watch to the VEGER V0102 portable charger.

Input: USB-C cable, 5V-1A

How to Check Battery Power Level

The LED indicator lights show the remaining battery power:

• 66%-100% Remaining
• 33%-66% Remaining
• 1%-33% Remaining
• 1% (Low battery)
• 0% (Out of juice)

Specifications

Gentle Reminder

In case you experience a delay while charging your Apple Watch, press the power button and wait for approximately 6-15 seconds. This should activate the charging process promptly.

Product Care & Use

• Keep away from liquids, fire, and extreme heat.
• Do not charge your devices while charging the power bank.
• Charge your V0102 at least once a month.
• Dispose of battery according to local environmental law.
• Do not disassemble by yourself.
• Avoid dropping.

Customer Service

For any questions or order issues, please contact via Amazon message tool or send an email to hello@vegerpower.com with your Amazon order number.

Note: VEGER provides after-sales service only for orders purchased from the VEGER Amazon Storefront. If you purchased from other sellers, please contact them directly for support.

Warranty: 12-month limited warranty, Lifetime technical support.

Website: https://www.vegerpower.com

Email: hello@vegerpower.com

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC ID: 2BCUX-V0102

Environmental Disposal (WEEE Directive)

The Waste Electrical and Electronic Equipment (WEEE) Directive is a European community directive that became European law in February 2003. Its main purpose is to prevent electronic waste by encouraging recycling and other forms of waste recovery. The symbol of a crossed-out trash can on the product or packaging indicates that used electrical and electronic products should not be disposed of with general household waste. It is your responsibility to dispose of all electronic or electrical waste at designated collection points. Correct disposal helps save valuable resources and protects the environment and human health. For more information, contact your local authorities, waste management companies, your retailer, or the manufacturer.

Authorized Representatives

UK Representative: TANMET INT'L BUSINESS LTD, 9 Pantygraigwen Road, Pontypridd, Mid Glamorgan, CF37 2RR, UK. Email: tanmetbiz@outlook.com, TEL: +442922550866

Germany Representative: EUBRIDGE ADVISORY GMBH, Virginia Str. 2, 35510 Butzbach, Germany. Email: eubridge@outlook.com, TEL: +4968196989045